Instruction manual

China – Busy Tone Detection Page 999 of 3156
Features and Services
Feature packaging
China - Busy Tone Detection requires Busy Tone Detection (BTD) package
294, which depends upon Meridian 1 Extended Peripheral Equipment (XPE)
package 203.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 97 – Busy Tone table configuration.
2 LD 14 – Busy Tone Detection Table and Busy Tone Supervision
assignment.
For China, the BTD table and its assignment to the various routes is automatic
and does not require configuration in LD 97 or LD 14, as long as the BTD
package is equipped. Only the configuration of Busy Tone Supervision in LD
14 is required.
LD 97 need only be changed if the values other than the default are required.
If table 0 is modified, rather than creating a new one, the assignment to the
trunk in LD 14 is not required. After the BTD table is created, or changed, the
data must be dumped and the system reloaded in order for the information to
be downloaded.
LD 97 – Busy Tone table configuration.
Prompt Response Description
REQ CHG Change existing data.
TYPE BTD Busy Tone Detection.
BTDT (0)-7
X1-X7
Busy Tone Detection Table.
BCAD Ph1 Ph2
(350 350)
Busy Tone Cadence. The input values are rounded to the
nearest multiple of 25 ms.
BTDD (BOTH)
INC
Busy Tone Detection allowed on both incoming and
outgoing calls.
Busy Tone Detection allowed on incoming calls only.