Instruction manual

Digital Trunk Interface – Commonwealth of Independent States Page 1273 of 3156
Features and Services
TKTP DID COT Trunk type, where:
DID = incoming trunks route, and
COT = outgoing trunks route.
...
DTRK YES Digital trunk.
DGTP DTI2 Digital trunk type for route.
...
ICOG ICT
OGT
Incoming trunk.
Outgoing trunk.
...
CNTL YES Changes to controls or timers.
TIMR DDL 0 Delay Dial Timer not needed.
TIMR DSI 49992 Disconnect supervision timer (five-second value, rounded
to the nearest 128 ms.).
TIMR EOD 13952 End of dial timer (default value).
TIMR SFB 25 Seize Fail Busy timer. The recommended value for trunks
with seizure supervision is 25 seconds.
TIMR GTI 0 Incoming Guard timer must be defined equal to zero.
Incoming CIS DTI2 trunks only. For CIS DTI2 trunks no
guard timing is necessary on the incoming side.
Immediately after sending the ”IDLE” signal, the incoming
trunk may be reseized by the CO.
TIMR ATO 128-(4992)-
65408
ANI time out timer in milliseconds. For CIS outgoing trunk
routes this defines the time delay performed after the
outpulsing of the toll access code. During this delay further
outpulsing is temporarily halted until the special message
from the card firmware confirms that a successful ANI
request/response interaction has been performed.
...