Instruction manual

Page 1266 of 3156 Digital Trunk Interface – Commonwealth of Independent States
553-3001-306 Standard 10.00 January 2002
The following packages are required:
• Flexible Tones and Cadences (FTC) package 125
• 2 Mbps Digital Trunk Interface (DTI2) package 129
• International Supplementary Features (SUPP) package 131
• Flexible Numbering Plan (FNP) package 160
• Meridian 1 Extended Peripheral Equipment (XPE) package 203
• Meridian 1 Extended Conference, TDS and MFS (XCT0) package 204,
and
• Meridian 1 Superloop Administration (XCT1) package 205.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 17 – Change system configuration data.
2 LD 73 – Define DTI2 data.
3 LD 73 – Define the SICA table for CDTI2/CSDTI2.
4 LD 97 – Define dial pulse make-break ratio.
5 LD 15 – Define busy tone/overflow tone time out.
6 LD 16 – Add or change route data for CIS DTI2 trunks.
7 LD 16 – Add or change route data for an incoming, non CIS DTI2, trunk.
8 LD 14 – Add or change trunk data for CIS DTI2 incoming and outgoing
trunk.
9 LD 10 – Specify ANI category for CIS DTI2 calls.
10 LD 11 – Specify ANI category for CIS DTI2 calls.
11 LD 12 – Specify ANI category for CIS DTI2 calls.
12 LD 27 – Add or change Digital Subscriber Loop (BRI set) for CIS.
13 LD 88 – Add or change the Authcode data block.
14 LD 56 – Configure the dial tone.