Instruction manual

Page 1254 of 3156 Digit Display
553-3001-306 Standard 10.00 January 2002
Operating parameters
Digit Display must be enabled for all console types in LD 15, using the
prompt OPT.
Only telephones equipped with a Digit Display module can use this feature.
The Display Time and Display Date key cannot be assigned to key 0.
Feature interactions
Attendant Break-In
During Attendant Break-In, the Attendant Console Digit Display shows the
DN of the incoming call and the destination DN until the Attendant extends
the incoming call to the destination DN and releases the connection.
Autodial Tandem Transfer
Digit Display allows the automatic display of information relevant to normal
call processing if the sets have display capability and the Class of Service is
ADD or DDS. When the THF key is pressed the display gets cleared, and
pressing the ADL key causes the ADL digits to be displayed. However, no
ADL digits will be displayed if no Tone and Digit Switch (TDS)/XCT is
available to generate the Dual-tone Multifrequency (DTMF) tones for the
ADL digits.
Automatic Redial
Dialed numbers are displayed when the Automatic Redial (ARDL) feature is
activated. The calling party can dial digits even though a busy tone indication
is given.
Digits dialed while on hold are not displayed.When the calling party accepts
a redialed call, the dialed numbers are displayed. If the Display (DSP) key and
appropriate RGA key are pressed while a call is on hold, the number redialed
is displayed.
China – Flexible Feature Codes - Outgoing Call Barring
Enhanced Flexible Feature Codes - Outgoing Call Barring
Meridian 1 proprietary telephones with displays do not display the OCB level
and the Station Control Password (SCPW) when OCB FFCs are dialed. This
protects the security of the SCPW.