Instruction manual

Page 1234 of 3156 Dial Intercom
553-3001-306 Standard 10.00 January 2002
Voice or ring may be specified on a DIG basis for Meridian 1 proprietary
telephones. If voice is specified, an idle station rings once for two seconds.
The calling party is then connected and may make a voice announcement. If
ring is implemented, normal ringing is received until the called party answers.
This feature provides the option of an announcement or a two-way speech
path.
The ring option must be used if a 500 telephone is a member of the group.
Distinctive ringing for Dial Intercom
This feature allows a user to differentiate between an incoming call and a Dial
Intercom (DI) call. The Dial Intercom (DI) ringing has a different cadence
than the regular Directory Number (DN) ringing and Distinctive Ringing.
Distinctive Ringing for DI is assigned on a per-customer basis. The cadence
is 0.5 sec. on and 0.5 sec. off, repeatedly.
Dial Intercom Handsfree Voice Call
Dial Intercom Handsfree Voice Call can be used with the following
telephones: M2112, M2317, and M2616.
Handsfree Voice Call provides the option of configuring VCC/DIG (with
voice option) to be answered in either handsfree mode or loudspeaker only
mode. Calls answered in handsfree (HVA) mode establish a two-way voice
path, while those answered in loudspeaker only (HVD) mode establish only
a one-way voice path from the calling telephone to the destination telephone.
Dial Intercom Handsfree Voice Call applies only to voice option DIG calls.
Operating parameters
A maximum of 2046 DIGs can be established per customer.
Calls are restricted to stations within the DIG only. Trunks cannot be accessed
using the DIG key, and cannot be added to a DIG call using the Conference
feature.
A DIG member number must be a single appearance Directory Number (DN)
within a specified DIG.