Instruction manual

Page 1206 of 3156 Controlled Class of Service, Enhanced
553-3001-306 Standard 10.00 January 2002
Feature operation
To activate Enhanced Controlled Class of Service (ECCS) from a Meridian 1
proprietary telephone with the feature currently inactive, follow these steps:
1 Press CCOS to begin the activation sequence.
Note that this is a toggle: if CCOS is already active, pressing the key will
change the CCOS state to inactive. Check the CCOS lamp to determine
if CCOS is already active.
2 Dial the PDN of the telephone to be changed and press CCOS. The
controlling telephone’s display, if equipped, shows the DN of the
changed telephone and a 0 (zero).
3 To select ECC1, dial # 1.
Note that the octothorpe (#) is required. The controlling telephone’s
display, if equipped, shows the DN of the changed telephone and a 1.
To select ECC2, dial # 2.
Note that the octothorpe (#) is required. The controlling telephone’s
display, if equipped, shows the DN of the changed telephone and a 2.
4 Press Rls.
To activate ECCS from an Attendant Console, follow these steps:
1 Select an idle loop key.
2 Press CCOS.
Note that this is a toggle: If CCOS is already active, pressing the key will
change the CCOS state to inactive. Check the CCOS lamp to determine
if CCOS is already active.
3 Dial the PDN of the telephone to be changed and press CCOS. The
console’s display shows the DN of the changed telephone. A 0 (zero) is
displayed if the telephone is active in the original CCOS mode.
If the telephone does not have CCOS or ECCS active, the console does
not acknowledge that you have successfully entered a valid CCOS DN.