Instruction manual

Page 1082 of 3156 CIS ANI Reception
553-3001-306 Standard 10.00 January 2002
TIMR ATO
2048-(2560)-5120
ANI Timeout timer. Defines how long Meridian 1 waits
for the ANI information from the CIS CO. If timer expires
before the ANI is uploaded from the CDTI2 card,
Meridian 1 treats the call as it is defined in the ANI
Failure Treatment option.
The ATO should be at least twice as large as the ARD.
CISR YES CIS Route
- CACD
(NO)
BEF
AFT
The option defines how the CAC is displayed on the
display of the set or console. The option also controls
presentation of the CAC in the messages to the
auxiliary processors. The options are:
NO = do not display CAC.
BEF= display CAC before ANI.
AFT= display CAC after ANI.
- CACC
(NO)
BEF
AFT
Defines how CAC is stored in CDR.
NO = do not store CAC
BEF = store CAC before ANI
AFT = store CAC after ANI
- AANI
(NO)
YES
The option defines if the Automatic ANI request should
be sent to the CIS CO when the incoming calls are
originated from the CIS CO to the trunks within this
route.
NO = do not send automatic request.
YES = send automatic request.
- ANFT
(CONT)
FAIL
ITDN
The prompt defines the ANI Failure Treatment option. It
is prompted only if the AANI is set to YES. The possible
options are:
Provide call to the required destination.
Drop call.
Transfer call to intercept DN.
- - ITDN <DN> Intercept DN (up to 8 digits) defines the DN to transfer
the incoming calls which failed to provide ANI. The
prompt appears if the ANFT option is set to ITDN.