Instruction manual

Page 1078 of 3156 CIS ANI Reception
553-3001-306 Standard 10.00 January 2002
Feature implementation
This section contains the overlay procedures required to configure the ANI
Reception feature.
Note: If Malicous Call Trace is used, turn to the Software Features
Guide for detailed MCT implementation instructions.
• LD 73 - The response MFA - Multifrequency Advanced has been added
to the CISFW prompt to support the ANI Reception and the Firmware
Dial Tone Detection features on the NTCK01AC and NTCK02AC cards.
When operating in the CIS mode, the NTCG01AA/02AA cards should
be configured as DP, and the NTCG01AB/02AB cards should be
configured as MFS.
• LD 14 - The CNA may be defined for the incoming DID DTI2 trunk if it
is configured on the CDTI2 loop with the CIS Firmware version set to
MultiFrequency Advanced in Overlay 73.
• LD 16 -Set the prompt CISR to YES to allow access to the CIS Route
prompts.
The following options are added for the CIS DTI2 routes:
• The Automatic ANI (AANI) option determines if the automatic ANI
request should be sent to the CIS CO party at the end of dialing on
incoming local calls. If the ANI information is required for gateway calls
this option should be set to YES.
• The ANI Failure Treatment (ANFT) option defines the treatment for
incoming calls which failed to provide ANI (see Note). The possible
options are:
— to provide the call to the required destination using the alternative
ANI to indicate the ANI Reception failure
— to drop the call
— to transfer the call to the predefined intercept DN using the
Alternative ANI to indicate the ANI Reception failure
• The Intercept DN (ITDN) prompt defines the intercept DN if the
intercept treatment option is selected.