Instruction manual

Collect Call Blocking Page 1157 of 3156
Features and Services
M911_ANI NO M911 route. Must be set to NO to enable CCB.
...
ISDN NO ISDN route. Must be set to NO to enable CCB.
...
ICOG IAO ICT OGT Incoming and outgoing, incoming, or outgoing. Must be
either IAO or ICT to enable CCB.
Must be either IAO or OGT to get the CCBA prompt for
outgoing calls.
...
CNTL (NO) YES Change to controls or to timers.
...
CCB (NO) YES Collect Call Blocking enabled or disabled on incoming
route. CCB package 290 is required. Enter YES to
obtain CCB timer prompts.
CCB1 512-(1536)-4992 Collect Call Blocking delay timer 1 in milliseconds. Input
rounded to the next multiple of 128 milliseconds.
CCB2 500-(1520)-2550 Collect Call Blocking delay timer 2 in milliseconds. Input
rounded to the next multiple of 10 milliseconds. If any
CCB route members (trunks) are using firmware timing
(FWTM = YES in LD 14), changes to the CCB2 timer
value will not take effect until the new timer value is
downloaded to the card. This can be done by enabling
the card or initializing the switch.
CCBA (NO) YES Collect Call Blocking allowed or denied for outgoing
route.