Instruction manual

CLASS: Calling Number and Name Delivery Page 1111 of 3156
Features and Services
General engineering guidelines
Non-Call Center applications
In a non-call center application, there is no significant number of agent sets.
Therefore, no agent set to regular set conversion is needed. The only type of
port requiring special treatment is trunk.
Configurations following engineering rules (no re-configuration
required)
The following engineering rules should be followed to avoid the need to re-
configure a switch to accommodate the CLASS feature.
1 Provide the number of CMOD units serving all CLASS sets in the system
based on the capacity table (Table 39).
2 Equip all CLASS sets in one network group.
3 Equip the XCMC IPE pack on the network group with CLASS sets.
If the system is a single group system, or if above rules are fully met, no
further engineering is necessary. However, in case of an existing multi-group
site upgrading to provide CLASS feature, we may need to re-configure the
system in order to satisfy rule (2).
When the above rules are not fully met, continue the system engineering by
following the procedure in the next subsection.