Instruction manual

CIS Toll Dial Tone Detection Page 1091 of 3156
Features and Services
LD 16 - Specify CIS route information.
Prompt Response Description
REQ NEW
CHG
Add new data.
Change existing data.
TYPE RDB Route Data Block.
TKTP COT Central Office Trunk
... ... ...
ICOG OGT Outgoing only trunk.
... ... ...
CNTL (NO) YES Deny/Allow changes to controls or timers.
- TIMR ATO 128-(4992)-65408 ANI timeout timer in milliseconds. For CIS outgoing
trunk routes this defines the time delay performed after
the outpulsing of the toll access code. During this
delay further outpulsing is temporarily halted until the
special message from the card firmware confirms the
satisfaction of the CIS Toll outpulsing criteria. If the
timer expires before satisfaction the behavior of the
system depends on the COAT prompt. If COAT is set
to YES the outpulsing continues on timeout. If COAT is
set to NO the call is dropped.
... ... ...
CISR YES CIS Route
- DTOC (NO) YES Deny/Allow Direct Toll Connection.
- CTOC
(DTDO)
AADT
ANIO
AODT
CIS Toll Outpulsing Criteria.
DTD Only.
ANI And DTD.
ANI Only.
ANI Or DTD.
- COAT (NO) YES NO = Drop Call when ATO timer expires.
YES = Continue Outpulsing when ATO timer expires.