Instruction manual

CIS ANI Digits Manipulation and Gateways Enhancements Page 1063 of 3156
Features and Services
- R_ENTRY aa
Xaa
Xaa Xbb
<CR>
ANI entry for an incoming route to be created or modified.
ANI entry for an incoming route to be deleted.
ANI entries for an incoming route between aa and bb to
be deleted.
Exit.
R_ENTRY is repeated until <CR> is entered. ANI entries
must be between 0 and (R_SIZE-1). For REQ=NEW, only
default table 0 is configurable. An R_ENTRY can be
deleted even if still assigned on an incoming route.
- - DNLG 0-(4)-15 DN Length
Number of digits of the Calling Line ID (CLID), Originating
Line Identifier (OLI), Calling Number Identification(CNI) to
use in the ANI message, starting with the less significant
digits.
- - LEC 0-99..99
X
Local Exchange Code, 1 to 15 digits.
Remove LEC.
- - ADDG 0-(8)-99...99 Additional digits, 1 to 15 digits. Used to complete ANI
Directory Number (ANDN) if Local Exchange Carrier
(LEC)+ANDN is less than ANSZ digits defined in LD 16.
- - ANDN 0-99...99
X
Used as ANI DN if calling number is not available or
DNLG=0. Up to 15 digits may be entered.
Remove ANDN.
CACC (NO) YES Deny/Allow Calling Party Category Code (CAC)
Conversion table option.