Instruction manual

Page 1062 of 3156 CIS ANI Digits Manipulation and Gateways Enhancements
553-3001-306 Standard 10.00 January 2002
CIS Gateways Enhancements feature implementation
This section contains the overlay procedures required to configure the CIS
Gateways Enhancements feature.
Feature implementation for R2MFC route
In case of gateway R2MFC/CIS it must be noticed that to be tandemed CNI
must be received on R2MFC route before outgoing CIS trunk is seized. This
is possible using an up-front CNI request. Up-front CNI request is defined on
R2MFC route by giving a non zero value to prompt NCNI. Configure the ANI
table entry and CAC conversion table for Incoming CIS DTI2 route using
LD 16.
LD 15 - Configure the ANI route table and CAC conversion table.
Prompt Response Description
REQ: NEW
CHG
Add new data.
Change existing data.
REQ = NEW, default table R_SIZE (0) is created.
REQ = NEW, default table CACC(0) is created.
REQ = NEW, R_SIZE defaults to number of ANI entries.
for incoming route created during conversion.
TYPE: ANI Automatic Number Identification
.... ... ....
ANLD xx...x ANI Listed Directory Number. Only included here for
clarification if this prompt appears. Only applies to North
American ANI.
CIS_ANI (NO) YES Deny/Allow configuration of ANI entries for CIS ANI
message.
... ...
- R_ SIZE (1)-512 Maximum number of ANI entries that can be configured
for incoming routes.
This maximum number is limited to 512 as it is the
maximum number of routes. Entries must be empty to
decrease R_SIZE.