Instruction manual

CIS ANI Digits Manipulation and Gateways Enhancements Page 1061 of 3156
Features and Services
LD 27 - Configure the CAC for CIS and MFC signaling for BRI sets.
- PRES (YES) NO Allow/Deny Presentation of CLID to far end on
outgoing calls.
- ANIE (0)-N ANI entry. It is of (0)-N where N=S_SIZE in customer
data block.
If ANIE=0, no entry is associated with the DN key.
The old mechanism is used for building the ANI
message.
If ANIE is 1-N:
• If ANIC=YES for the outgoing CIS route
where the call takes place, then the
components of the ANI message are
retrieved from the ANI entry in Customer
Data Block, if configured.
• If the given ANI Entry is not configured, or if
ANIC=NO for the outgoing CIS route where
the call takes place, then the old mechanism
is used for building the ANI message.
Prompt Response Description
REQ NEW
CHG
Add new data.
Change existing data.
TYPE DSL Digital Subscriber Loop.
DSL l s c dsl Digital subscriber loop address for large system, where:
• l (superloop) = 0-156 (must be 0 or a multiple of 4)
• s (shelf) = 0-1
• c (card) = 0-15
• dsl (Digital Subscriber Loop) = 0-7
... ...
CAC_CIS 0-(3)-9 CIS ANI category code.
CAC_MFC (0)-10 MFC CNI category code.