Instruction manual

Page 1974 of 3156 Malicious Call Trace
553-3001-306 Standard 10.00 January 2002
LD 16 – Set up MCTM timer and tandem delay (2 Mbps PRI for AXE-10 Australia only).
Feature operation
To trace a malicious call from an analog (500/2500 type) telephone:
1 Flash the switchhook. A special dial tone signifies that the call is on hold.
2 Enter SPRE+83. You are reconnected to the call.
To trace a malicious call from a Meridian 1 proprietary telephone using
Special Prefix (SPRE) code:
1 Press Transfer or Conference. A special dial tone signifies that the call
is on hold.
2 Enter SPRE+83. You are reconnected to the call.
To trace a malicious call from a Meridian 1 proprietary telephone using the
Trace (TRC) key:
1 Press Call Trace. You remain connected to the call.
P RRC(S) abcd Register recall signal activated by MCT.
TIME 10-(100)-630 Time of RRC(S) signal in milliseconds. This is the flash
duration used for 2.0 Mbit DTI trunks. It is programmable in
one-millisecond increments from 10 to 630.
Prompt Response Description
REQ NEW
CHG
Add new data.
Change existing data.
TYPE CDB Customer data block.
CUST 0-99
0-31
Customer number.
For Option 11C.
MCTS YES NO
MCTM (0) - 30 Malicious Call Trace timer (in seconds).
MTND (NO) YES Malicious Call Trace disconnect delay for tandem calls for
AXE-10 Australia.