Instruction manual

Page 1972 of 3156 Malicious Call Trace
553-3001-306 Standard 10.00 January 2002
Note: The FWTM prompt is provided for EXUT and XCOT cards. This
prompt should be set to YES if firmware timing is to be done for the flash
and the card supports this functionality. If the prompt is set to YES for
one unit, it is also set to YES for all other units.
CNTL YES Changes control or timers.
- TIMR FLH <space> 60-
(510)-32640
Hook Flash timer (in msec.)
The range for Centrex Switchhook flash timer is 256-(512)-
1536. For CAS, it is recommended that the timer be set at
768 or greater.
This timer must be at least 256 ms shorter than the remote
OGF timer and 256 ms shorter than the ICF timer.
• 60-89 ms = Digit 1 is sent
• 90 ms = Hard coded for XFCOT hook flash
• 91-255 ms = Digit 1 is sent
• 256-1536 ms = Existing software controlled hook
switch flash
Range for Centrex Switchhook flash timer is 60-(510)-1536
msec (the value is rounded to the nearest 10 msec).
Software controlled Centrex/Trunk Switch Flash timer range
of 60- 127 msec is done by sending digit 1.
The range of 128-1536 msec is already controlled by
Centrex Switchhook Flash feature.
Firmware flash user can enter any value from 60 to 1536.
FWTM must be YES in LD 14 for the trunk associated with
this route, if firmware timing is to be used.
...
MCTS (NO) YES Enter YES to get the new prompts
MCCD 0-8 digits The call trace request string can be 0-8 digits in length.
Valid digits are 0-9, *, and #.
MCDT (0)-4 Digit string delay is in seconds, in increments of one
second.