Instruction manual

Malicious Call Trace Page 1967 of 3156
Features and Services
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 10 – Enable MCT on an Analog (500/2500 type) telephone.
2 LD 11 – Enable MCT on a Meridian 1 Proprietary Telephone.
3 LD 17 – Allow printing of the MCT record on a dedicated MCT TTY
port.
4 LD 16 – Set up the recorder route.
5 LD 14 – Set up the recorder trunk.
6 LD 15 – Set up the recorder and alarm options.
7 LD 16 – Set up the alarm for external calls.
8 LD 57 – Define the MCTFFC.
9 LD 16 – Configure the call trace string.
10 LD 14 – Enable Firmware timing for trunk hook flash (if available).
11 LD 73 – Define the DTI2 flash time range.
12 LD 16 – Set up MCTM timer and tandem delay (2 Mbps PRI for AXE-
10 Australia only).
Note: In order to activate Malicious Call Trace from an analog (500/
2500 type) telephone, the user has to dial SPRE + two-digit access code
(83) or the MCT Flexible Feature Code FFC.