Product Manual

MTM Hydro Inc.
components and accessories for high pressure cleaners and car wash industry
7430 Washington Ave. So. - Eden Prairie, Minnesota 55344
phone [phone] - 866.MTM.4020 - fax [phone] - 866.MTM.4021
www.mtmhydro.com - [e-mail]
USER MANUAL
MUM088_3
update: Feb. 23, 2009 Page 1 di 2
FOAM JET KIT – Part Number 14.0289
Technical data:
Product preparation
1) Properly assembly one of the following nozzles (supplied with the kit) on the base of your pressure washer rating :
o Part # 36.0227 S.Steel nozzle Ø1,25mm – 3.5 for 3000 psi Pressure Washers
o Part # 36.0235 S.Steel nozzle Ø1,50mm – 5.0 for 4000 psi Pressure Washers
o Part # 36.0236 S.Steel nozzle Ø1,70mm – 6.5 for 5000 psi Pressure Washers
2) Screw the Foam Jet inlet
into the outlet of your
pressure washer (gun,
lance, hose etc.)
3) Put the end of the suction hose with filter into your
chemical container.
4) Take the suction hose and push the
open end of the hose onto the brass
hose barb.
5) Make sure that the shut off valve is in the
OFF position before you begin using the
tool.
Product use:
With the pressure washer on, you can now apply chemicals by turning the shut off valve to the ON position (picture1); please consider that with the total
opening of the shut off valve, the suction is around 0.26 USgpm.
picture 1
Turning the upper handle (picture 2) you can regulate the air, water and chemical mix, in order to adjust the foam density.
picture 2
Turning the outlet handle you can go from a fan-jet (picture 3) to a pin-jet (picture 4).
picture3 picture4
max Pressure 5000 psi
max Flow 5.6 USgpm
max Temperature 140 °F
WARNING:
rinse with clear water after use
every day to kee
p the Foam Jet Kit clean
and grant smooth functioning