Owner's Manual

CHROMATHRAPY - KEYPAD FUNCTIONS
ON/OFF BUTTON:
1st Press: White light. LED light on (White is only available when
the system is initially turned on).
2nd Press: Light off. LED light off.
Press the on/off button - Light must be on for any mode to function.
MODE BUTTON FUNCTIONS:
1st Press: Aqua-Blue-Green Cycle. - First cycle 1.5 seconds between color
changes; then slows to 6 seconds between color changes.
2nd Press: Rainbow Cycle - Colors change from Aqua-Blue-Magenta-Red-Orange-Yellow-Green. First
cycle 1.5 seconds between color changes; then slows to 6 seconds between color changes.
3rd Press: Pressing the Mode button a third time will stop the system on the color displayed.To
change the color, use the up & down buttons to go through each color change in small increments.
(Alternatively, you could turn the light off and start over.)
UP ARROW FUNCTIONS:
To Change the Light Color - Pressing the up arrow will allow the lights to change through the basic
colors: Aqua, Blue, Magenta, Red, Orange, Yellow and Green.
When in the Rainbow Cycle - Press & hold to increase the cycle speed. Release pressure at the desired speed.
When in the Aqua-Blue-Green Cycle - Press & hold to increase the cycle speed. Release
pressure at the desired speed.
DOWN ARROW FUNCTIONS:
To Change the Light Color - Pressing the up arrow will allow the lights to change through the basic
colors: Aqua, Blue, Magenta, Red, Orange, Yellow and Green.
When in the Rainbow Cycle - Press & hold to decrease the cycle speed. Release pressure at the desired speed.
When in the Aqua-Blue-Green Cycle - Press & hold to decrease the cycle speed. Release
pressure at the desired speed.
OPT
IONAL EQUIPMENT OPERATING INSTRUCTIONS
INLINE HEATER
Depress the on/off button to turn the system on, press again to turn the system off. The system gently
recirculates the bath water through the inline heater, with negligible disturbance to the water. The heatsoak
system requires a dedicated 110 V
AC, 20 AMP, GFCI protected outlet. Both the pump and inline heater
must be plugged in for system to operate properly.
RADIANCE
To turn the system on, press the button on the touchpad.
The light on the touchpad will be on. Radiance is designed
to be left on continually as the initial heating can take about
an hour. The system uses less energy than a standard
light bulb. To turn the system off, press the button again.
The system will turn off in the event of a power surge or
power failure. Must have access to transformer box for
future servicing - test prior to installing.
Rectangular touchpad
for rectangular, square &
corner tubs
Round touchpad
for round & oval tubs