Specification Sheet

Effective 010116 ©2015 by MTI Baths, Inc. Modication Rights Reserved.
B-261
CSA # MTI-153
57"
49"
3
4
1
2
24½"
32"
4"
4"
3¾"
8½"
66"
16"
120°
107°
22"
14¾"
18½"
20½"
17"
Features integral skirting and tile flange.
Numbered areas on tub deck represent possible locations to install cleaning systems, faucets and other xtures.
Shown with Air Massage and Ultra Whirlpool Package.
Designer Collection Tubs
Model # 153
Cameron 3
66" x 32" x 20.5"
Compliance Label
Model MTXXXX
Made in USA
Complies with
ANSI Z124.1-1995
CSA Certified C/US
GENERAL SPECIFICATIONS:
Material - Acrylic
Installation - Alcove
Plumbed Weight - 140 lbs / 64 kg
Soaker Weight - 115 lbs / 52 kg
Average Fill - 40 gal to above jet level
Maximum Fill - 67 gal to overflow
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.
See the "Designer Collection Tubs Installation & Operation Manual" included
with tub delivery or go to mtibaths.com/support/installation_operation/
manuals for all the information necessary to install and operate the tub.
MTI's Customer Service Department is available Monday-Friday 8am-6pm EST
at 800-783-8827 or [e-mail] to answer any questions
pertaining to ordering or installation.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
• Before ordering or installing, please consider future access to equipment.
• Cameron includes integral front skirting, tile flange on 3 sides and a pre-leveled
foam base to facilitate the installation process.
• Tub is available with a left- or right-hand drain location. Must specify on order.
• Overall standard tub height is 20.5", but can be reduced by as low as 18.5"
ONLY when ordered as a soaker. Must specify on order.
• Skirting is non-removable and provides no access. Must have end access
for servicing of equipment.
• If you plan to use a glass enclosure, MTI must be advised when ordering for
possible relocation of systems controls.
• Suction and control locations may vary.
• Specifications and configurations are subject to change without notice.
• Measurements are +1/2" and are subject to change without notice.
• Measurements herein supersede all others published prior to publication
date shown below.
ELECTRICAL COMPONENTS & SPECIFICATIONS
Required Electrical Service - 110 Volt
Hydrotherapy Package Components Included GFCI
Standard Whirlpool 2-bhp pump 1-15 amp
Ultra Whirlpool 2-bhp pump, inline heater 2-15 amp
Air Massage heated blower 1-15 amp
Air Massage Elite heated blower, chromatherapy 1-15 amp
Air Massage with
Standard Whirlpool
2-bhp pump, heated blower 2-15 amp
Air Massage with
Ultra Whirlpool
2-bhp pump, inline heater,
heated blower
2-20 amp
Air Massage Elite with
Standard Whirlpool
2-bhp pump, heated blower,
chromatherapy
2-15 amp
Air Massage Elite with
Ultra Whirlpool
2-bhp pump, inline heater,
heated blower, chromatherapy
2-20 amp
For electrical requirements of tub options, see page C-2.
CSA Certified C/US; ANSI Z124.1 for plastic tubs and ANSI 112.19.7 for whirlpool components.