Specification Sheet

Eective 012618 ©2018 by MTI Baths, Inc. Modification Rights Reserved.
See the "Designer Collection Tubs Installation & Operation Manual" included with tub delivery or go to mtibaths.
com/support/installation_operation/manuals for all the information necessary to install and operate the tub.
MTI's Customer Service Department is available Monday-Friday 8am-6pm EST at
800-783-8827 or [e-mail] to answer any
questions pertaining to ordering or installation.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
• Before ordering or installing, please consider future access to equipment.
• Add bedding compound to fully level and support bottom of tub.
• Tubs equipped with an air bath or a pre-leveled foam base are designed to rest on the floor
without bedding compound, provided the floor is level.
• Overall tub height is increased by approx. 2-3" when tub is equipped with any air bath pack-
age or when pre-leveled foam base or frame system is ordered.
• Please measure tub on-site before building tub decking.
• If you are planning to use a glass enclosure, MTI must be advised when ordering for possible
relocation of controls.
• Suction and control locations may vary.
• Specifications and configurations are subject to change without notice.
• Measurements are +1/2" and are subject to change without notice.
• Measurements herein supersede all others published prior to publication date shown below.
1 of 3
CSA # MTDS-65
ELECTRICAL COMPONENTS & SPECIFICATIONS
Required Electrical Service - 110 Volt
Hydrotherapy Package Components Included GFCI
Standard Whirlpool 2-bhp pump 1-15 amp
Air Massage heated blower 1-15 amp
Air Massage Elite heated blower, chromatherapy 1-15 amp
Air Massage with
Standard Whirlpool
2-bhp pump, heated blower 2-15 amp
Air Massage Elite with
Standard Whirlpool
2-bhp pump, heated blower,
chromatherapy
2-15 amp
For electrical requirements of tub options, see specific options specs
CSA Certified C/US; ANSI Z124.1 for plastic tubs and ANSI 112.19.7 for whirlpool
components.
GENERAL SPECIFICATIONS:
Material - Acrylic
Installation - Drop-in or undermount
Not recommended as a tub / shower combination.
Plumbed Weight - 150 lbs / 68 kg
Soaker Weight - 100 lbs / 45 kg
Average Fill - 38 gal to above jet level
Maximum Fill - 71 gal to overflow
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.
IMPORTANT:
Air baths and tubs with
a pre-leveled foam base
or frame system add 2-3"
to overall tub height.
Designer Collection Tubs
Model # 65
Atlantica
50" x 23.625" / 34.75 x 23.75"
Compliance Label
Model MTXXXX
Made in USA
Complies with
ANSI Z124.1-1995
CSA Certified C/US
1¾"
23"20"
50"
34¾"
28¾"24¼"
40"
44"
20"
23
5⁄8"
45 degrees
45 degrees
11 "
1
8
11 "
1
8
9"
2½"
11
"
1
8
11 "
1
8
20"
3"
3½"
1
2 3
4
22"
23¾"
19¼"
105°
4"
Numbered areas on tub deck represent possible locations to install cleaning systems, faucets and other fixtures.
Pump extends 6"-7" beyond edge of tub.
Shown with Air Massage and Standard Whirlpool Package.
PLEASE NOTE:
This tub is very small
and is intended for
applications where space
is extremely limited.