Installation Instructions

IMPORTANT! Read all instructions carefully before beginning installation or drilling of sink.

1. Locate the two templates provided. Template #1 is the inner cutout. Template #2 is the outer cutout for the

sink. Mark both cutouts on the slab prior to cutting.

2. Using an angle grinder with granite cutting contour blade, cutout the inner most elliptical piece of countertop.

This piece will be re-used as the insert in the finished sink. Make the cutout slightly larger to compensate for

grinding and polishing.

3. Carefully remove the innermost remnant and store in a safe location. Further instructions regarding this

piece are continued on line #8.

4. Widen the cutout in the slab to fit the outermost #2 template dimensions.

5. Insert the sink through cutout and check for proper fit. If sink does not fit properly, lift sink and rotate 180

degrees. Complete installation using a bead of clear silicone.

6. Take innermost remnant and drill (2) 1-1/4” diameter, half moon finger pulls, centered on the left and right

edges. Please see template.

7. Mark the center point of the insert. From the center, grind a gradual slope towards the edge of the insert,

which will facilitate the drainage of the water on the insert. Make sure to keep the center point the highest point.

8. Finish top face and all edges of inner remnant to the template markings. It is ideal to have a 1/8” gap

between the sink and the insert to allow for drainage. Each Sink is hand crafted and some adjustments to

outer edge of inner remnant may be necessary to achieve uniform 1/8” gap.

9. Locate and mark adjustable leg base plate locations on underside of inner remnant. Avoid placing any legs

over the drain location. Legs adjust from 2-1/8 to 3-1/8” in height.

10. Install adjustable legs in a triangular pattern to bottom of inner remnant using two part epoxy. Legs adjust to

accept material 1/2" to 1-1/2" thick.

11. Measure distance from bottom inside of sink to top of outer countertop.

12. Adjust legs to replicate the height measured on line #10.

13. Insert finished remnant to align with outer countertop height. If insert foes not hit properly, lift insert and

rotate 180 degrees..

Boutique Collection - SculptureStone

™

Installation - Semi-Recessed Continuum Sink

PAGE 1
Boutique Collection - SculptureStone™ Installation - Semi-Recessed Continuum Sink IMPORTANT! Read all instructions carefully before beginning installation or drilling of sink. 1. Locate the two templates provided. Template #1 is the inner cutout. Template #2 is the outer cutout for the sink. Mark both cutouts on the slab prior to cutting. 2. Using an angle grinder with granite cutting contour blade, cutout the inner most elliptical piece of countertop.
PAGE 2
Boutique Collection - SculptureStone™ Care and Cleaning - Lavatory Sinks and Counter-Sinks CARE AND CLEANING INSTRUCTIONS For Matte Finish The SculptureStone™ surface of all MTI Boutique Collection lavatory sinks is among the highest quality surfaces available. Its hard, non-porous surface prevents dirt from accumulating and resists stains better than other materials. With normal use, the SculptureStone will retain its beauty with only a minimal amount of care.
PAGE 3
Boutique Collection - SculptureStone™ Warranty - Lavatory Sinks and Counter-Sinks Residential Warranty This warranty is effective for all MTI SculptureStone sinks manufactured after January 1, 2007, and is in lieu of all other warranties. MTI Baths provides a limited five year warranty on sinks for use in the continental United States to the original purchaser for personal or single family use. Warranty begins on date of purchase (regardless of installation date).