Owners Manual / Installation Guide

2) Install drain asse
mbly onto trough so it looks like this:
**This drain asse
mbly does not have grates by design so objects can move easily to P-trap
and no clogging at drain will occur.
Countersink Installation:
1) Install countersink onto vanity. Follow instructions above for attaching the drain trough
assembly to the sink.
2) Sink is now ready for P-trap attachment
3) Once the drain and trough are assembled and the surfaces cleaned, put a thick bead of clear
silicone adhesive on the trough lip (shown above in picture) all the way around the entire
perimeter.
4) Place trough onto sink bottom (flat area) making sure that the trough completely covers the
slot opening in the sink. Allow time
for Silicone adhesive to cure completely. Please refer to
sil
i
cone cure instructions. Please note: You MUST use silicone adhesive, NOT
clear kitchen &
bath silicone.
5) Water test for leaks, and if found, repeat the mounting procedure. Once sink is leak free, it is
now ready for under mount installation.