Specification Sheet

Eective 012618 ©2018 by MTI Baths, Inc. Modification Rights Reserved.
See the "Designer Collection Tubs Installation & Operation Manual" included with tub delivery or go to mtibaths.
com/support/installation_operation/manuals for all the information necessary to install and operate the tub.
MTI's Customer Service Department is available Monday-Friday 8am-6pm EST at
800-783-8827 or [e-mail] to answer any
questions pertaining to ordering or installation.
1 of 3
CSA # MTDS-43
ELECTRICAL COMPONENTS & SPECIFICATIONS
Required Electrical Service - 110 Volt
Hydrotherapy Package Components Included GFCI
Standard Whirlpool 2-bhp pump 1-15 amp
Air Massage heated blower 1-15 amp
Air Massage Elite heated blower, chromatherapy 1-15 amp
Air Massage with
Standard Whirlpool
2-bhp pump, heated blower 2-15 amp
Air Massage Elite with
Standard Whirlpool
2-bhp pump, heated blower,
chromatherapy
2-15 amp
For electrical requirements of tub options, see specific options specs
CSA Certified C/US; ANSI Z124.1 for plastic tubs and ANSI 112.19.7 for whirlpool
components.
IMPORTANT:
Air baths and tubs with
a pre-leveled foam base
or frame system add 2-3"
to overall tub height.
Designer Collection Tubs
Model # 43
Mirage
59.5" x 30.5" / 42" x 19.75"
Compliance Label
Model MTXXXX
Made in USA
Complies with
ANSI Z124.1-1995
CSA Certified C/US
53½"
45½"
16 "
59½"
30½"
42"
3"
4"
34"
29½"
14 "
7¾"
16 "
4"
3"
19¾"
17"
19"
119°
92°
Available with left- or right-hand drain.
When ordered with Install Ease frame & skirt package, wall-mount valves are required.
Shown with Air Massage and Standard Whirlpool Package.
GENERAL SPECIFICATIONS:
Material - Acrylic
Installation - Drop-in (cannot be undermounted)
Plumbed Weight - 150 lbs / 68 kg
Soaker Weight - 100 lbs / 45 kg
Average Fill - 45 gal to above jet level
Maximum Fill - 85 gal to overflow
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
• Before ordering or installing, please consider future access to equipment.
• When ordered with Install Ease package, wall-mount valves are required.
• Must choose left- or right-hand drain on order.
• Add bedding compound to fully level and support bottom of tub.
• Tubs equipped with an air bath or a pre-leveled foam base are designed to rest on the
floor without bedding compound, provided the floor is level.
• Overall tub height is increased by approx. 2-3” when tub is equipped with any air bath
package or when pre-leveled foam base or Install Ease package is ordered.
• Please measure tub on-site before building tub decking.
• Suction and control locations may vary.
• Specifications and configurations are subject to change without notice.
• Measurements are +1/2” and are subject to change without notice.
• Measurements herein supersede all others published prior to publication date shown
below.