Specification Sheet

ELECTRICAL COMPONENTS & SPECIFICATIONS
Required Electrical Service - 110 Volt
Hydrotherapy Package Components Included GFCI
Air Massage heated blower 1-15 amp
Air Massage Elite heated blower, chromatherapy 1-15 amp
For electrical requirements of tub options, see specific options specs
CSA Certified C/US; ANSI Z124.1 for plastic tubs and ANSI 112.19.7 for whirlpool
components.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
• Before ordering or installing, please consider future access to equipment.
• Unless ordering Sculpted Finish on 4 sides, please include a diagram specifying which sides
will need to be finished, along with location of optional tile flange.
• Overflow must be factory installed if drain end is sculpted. Please select drain from options on
next page.
• When ordering an air bath, the air blower must be remote mounted.
• Microbubbles system components must be installed on a non-Sculpted Finish side.
Components will extend beyond the perimeter of the tub. Call MTI for specific details
regarding the desired installation before placing the order.
• Radiance placed on floor locations will affect placement of air jets.
• If tub is equipped with Chromatherapy, the control box must be remote mounted.
• Specifications and configurations are subject to change without notice.
• Measurements are +1/2" and are subject to change without notice.
• Measurements herein supersede all others published prior to publication date shown below.
See the "Designer Collection Tubs Installation & Operation Manual"
included with tub delivery or go to:
mtibaths.com/support/installation
for all the information necessary to install and operate the tub.
MTI's Customer Service Department is available
Monday-Friday 8am-6pm EST at 800-783-8827 or
[e-mail]
to answer any questions pertaining to ordering or installation.
*Sculpted Finish is standard on 4 sides, creating a freestanding tub design.
Also available finished on 1, 2 or 3 sides for various installation applications.
Eective 072519 ©2019 by MTI Baths, Inc. Modification Rights Reserved.
CSA # MTDS-239A
The Sculpted Finish process does not allow enough space for mounting fixtures on the tub deck.
Shown with Air Massage Package.
GENERAL SPECIFICATIONS:
Material - Acrylic
Installation - Freestanding* (see note to left)
Soaker Weight - 135 lbs / 61 kg
Maximum Fill - 71 gal to overflow
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.
Andrea 28
with Sculpted Finish
®
66" x 30" x 22"
Designer Collection Tubs
Model # 239A