Owners Manual / Installation Guide

Installation and Operational Manual

Boutique Collection

Solid Stone® Tubs

mtibaths.com / 10

Operation Instructions

1. ON/OFF

2. BLOWER SPEED INCREASE

3. BLOWER SPEED DECREASE

4. SPA MODES

1st Press: The blower starts. LED light on.

Press & hold to increase the blower speed. Release

pressure at the desired speed.

The system is equipped with two sensors on the ﬂoor of the bath near the drain. Every time water is introduced

to the bath and drained, either by showering, bathing or cleaning, the sensors will activate the drying cycle. The

cycle will start approximately 7 minutes after the bath is drained and run for 1-2 minutes. The drying cycle will

activate even when the air system has not been turned on. The blower LED blinks (on keypad only) during the

drying cycle countdown. This countdown cannot be cancelled. Any attempt to cancel this cycle only resets the

countdown timer.

Press & hold to decrease the blower speed. Release

pressure at the desired speed.

2nd Press: The blower stops. LED light o.

1st Press (Wave): Speed will vary gradually from

maximum to minimum. LED light on.

2nd Press (Pulse): Speed will go directly to minimum

and then straight back to maximum. LED light will ﬂash.

3rd Press: Returns to maximum speed. LED light o.

Press button #3 to decrease blower speed.

Note: The blower initially starts at 30% speed.

Operation Instructions – Airbath Keypad and Remote

Airbath Keypad

Airbath Remote Control

FUNCTIONS:

Note: Blower automatically stops after 20 minutes.

STANDARD DRYING CYCLE WITH WATER DETECTORS:

Note: Numbered instructions depict buttons in photo as seen from left to right on keypad or top to bottom on

remote control.

Please visit mtibaths.com/support/installation-operation/ for detailed operation instructions.

OPERATIONAL VIDEOS:

1 2 3 4