Specification Sheet

Eective 012618 ©2018 by MTI Baths, Inc. Modification Rights Reserved.
See the "Designer Collection Tubs Installation & Operation Manual" included with tub delivery or go to mtibaths.
com/support/installation_operation/manuals for all the information necessary to install and operate the tub.
MTI's Customer Service Department is available Monday-Friday 8am-6pm EST at
800-783-8827 or [e-mail] to answer any
questions pertaining to ordering or installation.
ELECTRICAL COMPONENTS & SPECIFICATIONS
Required Electrical Service - 110 Volt
Hydrotherapy Package Components Included GFCI
Standard Whirlpool 2-bhp pump 1-15 amp
Ultra Whirlpool 2 2-bhp pumps, inline heater 2-20 amp
Air Massage heated blower 1-15 amp
Air Massage Elite heated blower, chromatherapy 1-15 amp
Air Massage with
Standard Whirlpool
2-bhp pump, heated blower 2-15 amp
Air Massage with Ultra
Whirlpool
2 2-bhp pumps, inline heater,
heated blower
2-20 amp
Air Massage Elite with
Standard Whirlpool
2-bhp pump, heated blower,
chromatherapy
2-15 amp
Air Massage Elite with
Ultra Whirlpool
2 2-bhp pumps, inline heater,
heated blower, chromatherapy
2-20 amp
For electrical requirements of tub options, see specific options specs
CSA Certified C/US; ANSI Z124.1 for plastic tubs and ANSI 112.19.7 for whirlpool
components.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
• Before ordering or installing, please consider future access to equipment.
• Add bedding compound to fully level and support bottom of tub.
• Tubs equipped with an air bath or a pre-leveled foam base are designed to rest on the floor
without bedding compound, provided the floor is level.
• Overall tub height is increased by approx. 2-3" when tub is equipped with any air bath pack-
age or when pre-leveled foam base or frame system is ordered.
• Please measure tub on-site before building tub decking.
• If you are planning to use a glass enclosure, MTI must be advised when ordering for possible
relocation of controls.
• Suction and control locations may vary.
• Specifications and configurations are subject to change without notice.
• Measurements are +1/2" and are subject to change without notice.
• Measurements herein supersede all others published prior to publication date shown below.
1 of 3
CSA # MTDS-36
IMPORTANT:
Air baths and tubs with
a pre-leveled foam base
or frame system add 2-3"
to overall tub height.
Designer Collection Tubs
Model #36
Compliance Label
Model MTXXXX
Made in USA
Complies with
ANSI Z124.1-1995
CSA Certified C/US
Numbered areas on tub deck represent possible locations to install cleaning systems, faucets and other fixtures.
Shown with Air Massage and Ultra Whirlpool Package.
44½"
37"
11"
60"
49¼"
84¼"
3
1
2
32½"32½"
6"
59 "
7
8
24 "
5
8
24¾"
24¾"
24¼"
48¼"
60"
19 ½"
26¼"
23½"
22½"
102°
Cayman 4
59.875" x 59.875" x 24.25"
GENERAL SPECIFICATIONS:
Material - Acrylic
Installation - Drop-in (cannot be undermounted)
Not recommended as a tub / shower combination.
Plumbed Weight - 185 lbs / 84 kg
Soaker Weight - 120 lbs / 55 kg
Average Fill - 56 gal to above jet level
Maximum Fill - 86 gal to overflow
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.