Owners Manual

Installation and Operational Manual
°
Designer Collection
°
Acrylic Freestanding Tubs
11 / mtibaths.com
Operation Instructions
Please visit mtibaths.com/support/installation-operation/ for detailed operation instructions.
OPERATIONAL VIDEOS:
BLOWER SPEED DECREASE
Press & hold to decrease the blower speed. Release pressure at the desired speed.
ON/OFF
1st Press: The blower starts. LED indicator light on.
2nd Press: The blower stops. LED indicator light o.
SPA MODES
1st Press (Wave): Speed will vary gradually from maximum to minimum. LED indicator light is on.
2nd Press (Pulse): Speed will go directly to minimum and then straight back to maximum. LED
indicator light will flash.
3rd Press: Returns to maximum speed. LED indicator light o. Press button #3 to decrease blower
speed.
BLOWER SPEED INCREASE
Press & hold to increase the blower speed. Release pressure at the desired speed.
Note: The blower initially starts at 30% speed.
Operation Instructions - Combined Therapy
Note: Blower automatically stops after 20 minutes.
Sensors on the floor near the drain will activate the drying cycle approximately 7 minutes after the bath is
drained and run for 1-2 minutes. The drying cycle will activate even when the air system has not been turned
on. The blower LED blinks (on keypad only) during the drying cycle countdown. This countdown cannot be
cancelled. Any attempt to cancel this cycle only resets the countdown timer.
STANDARD DRYING CYCLE WITH WATER DETECTORS:
Standard Airbath
ON/OFF FOR RADIANCE
1st Press: Turns on both heated zones LED indicator light on.
2nd Press: Turns o Radiance system. LED indicator light o.
See Standard Airbath above for operation instructions for the remaining buttons.
Note: The blower initially starts at 30% speed.
#1 System
Airbath with Radiance®
#1R System