Installation Sheet

18
# 9 ULTRA THERAPY WHIRLPOOL /
AIR SYSTEM COMBINATION
WITH LED LIGHTING
FUNCTIONS
ON/OFF FOR AIR SYSTEM
1st Press: The blower turns on at 30% power. Use the up and down arrows to increase or decrease
the speed. Please note: 20% is the minimum. If the lights for the up & down arrows go off, they can
be reactivated by gently pressing the on/off button
2nd Press: The blower turns off.
WHIRLPOOL PUMP ON/OFF - LARGE POINT-MASSAGE JETS
1st Press: The pump turns on. Use the air volume control to adjust the pressure felt from the jets.
2nd Press: The pump turns off.
ON/OFF FOR MICRO-JETS / TSUBO MASSAGE
IMPORTANT! YOU MUST TURN THE VOLUME CONTROL FOR THE MICRO-JETS DOWN UNTIL YOU
ARE SITTING IN FRONT OF THEM. IF ACTIVATED BEFORE, WATER MAY SPLASH OUTSIDE THE BATH.
1st Press: Turns the micro-jets on full power. Adjust the flow from the jets by turning the cluster control knobs.
Use the up / down arrows to pass to the next of 7 pulsation modes. If the light on the arrows turns off, gently
press the on/off button to reactivate them.
2nd Press: Pump is in pulse mode and will automatically advance to the next pulsation mode every 10 seconds.
3rd Press or press and hold for 1 second: Pump off. The pump has an auto shut off after 15 min-
utes and a lock out timer. See "Additional System Information" on next page.
ON/OFF FOR LED LIGHTS
1st Press: Turns lights on to basic color mode, starting with white. Use the up and down arrows to
move light through the basic colors.
2nd Press: Slow rainbow cycle - Use up and down arrows to increase or decrease the speed of the cycle.
3rd Press: Slow aqua-blue-green cycle. Use the up / down arrows to adjust the speed of the cycle.
If the lights for the up /down arrows go off, they can be reactivated by gently pressing the on/off button.
Press and hold light button at any time to turn light off.
SPA MODES
1st Press: Turns the Spa Mode on. There are three different pre-set Spa Modes. Energetic, Relaxing and
Deep Tissue. Use the up and down arrows to choose from the different selections. Each Spa Mode will
operate the tub functions automatically for 20 minutes. Simply sit back and enjoy!
2nd Press or press and hold for one second: Spa Mode off.
SEQUENTIAL PULSE MODE - FOR MICRO-JETS
The sequential pulse mode automatically advances the system through the seven different Tsubo modes
every 10 seconds, when selected. To select this mode activate the micro jets; press and hold the Tsubo
Mode button / up arrow for 3 seconds. To cancel, press button up or down arrow on the keypad.
AUTOMATICALLY STOPS AFTER 20 MINUTES
NOTE: The air blower will turn on by itself approximately 7 minutes after tub is completely drained.
The system is also equipped with a Tsubo lock-out protection mode for the micro-jets.
See p. 19 for more information.