Installation Sheet

1
INSTALLATION AND OPERATION GUIDELINES
Read all instructions before installing tub. Installer / product owner is responsible for complying with all state and local
codes. Warranty coverage will be void if unit is not tested and installed per the enclosed instructions. MTI strongly
recommends using licensed professionals to install this product. Warning: Certain cleaning products will perma-
nently damage the acrylic surface. Read product label carefully before using any cleaning product. Never
use anything abrasive, aerosol sprays or any product that is described as “scrubbing bubbles”.
Never leave a full or filling bath unattended.
BEFORE INSTALLING:
Inspect tub thoroughly.
A. Damage from shipping or delivery must be reported to carrier immediately. Do not install
damaged tub. MTI is not responsible for damage occurring in transit.
B. Factory defect must be reported to factory before tub is installed. Defects or damage claimed
after installation will be excluded from warranty.
C. Important - Measure tub on site carefully. Specifications are subject to change without notice.
MTI is NOT responsible for any preparatory labor or materials.
ATTENTION INSTALLER!
THIS TUB MUST BE TESTED FOR OPERATION AND LEAKS PRIOR TO ENCLOSURE OF
SURROUNDING AREAS. FAILURE TO DO SO WILL VOID WARRANTY. THIS TUB WAS WATER
TESTED AT THE FACTORY AND FOUND TO BE FULLY OPERATIONAL AND LEAK-FREE PRIOR TO
SHIPPING. FREIGHT, HANDLING AND JOB SITE EXPOSURE MAY HAVE DETERIORATED THE TUB’S
CONDITION. IT IS THE RESPONSIBILITY OF THE INSTALLER TO THOROUGHLY TEST THE UNIT
PRIOR TO INSTALLATION. TUBS ARE INTENDED FOR INDOOR USE ONLY. TUBS ARE WARRANTED
FOR INDOOR INSTALLATION IN A CLIMATE CONTROLLED ENVIRONMENT ONLY.
TEST PROCEDURES
1. Place the tub on a flat surface such as the driveway.
2. Seal the drain with tape.
3. Fill tub to overflow and allow tub to stand for five minutes without the blower running. NOTE: The
overflow is a plumbing device designed to prevent water from reaching a certain level in your tub.
DO NOT, under any circumstances, tape off or block the overflow in any way. Any controls located
above the normal water line are designed to be water-resistant, not water-proof. The controls will
not leak under normal usage, however, they are not warranted against leaks when improperly used
or subjected to conditions for which they were not designed.
4. Plug in the blower and any other components into a 110v GFCI outlet. Start the equipment and
check for leaks by examining the area underneath and surrounding the tub.
5. Check that all optional equipment is functioning properly and that the features on the tub match
exactly what was ordered.
6. If any leaks or operating problems are discovered, do not complete installation until problems
are resolved. MTI will not be responsible for leaks claimed after the tub is installed, nor any costs
involved with removing or reinstalling the tub or the costs of any surrounding materials or labor.
See troubleshooting section of this manual, call for assistance at 800-783-8827 or email
[e-mail].
Always protect tub from construction damage by using a protective cover. Damage, including chips
and scratches, incurred at the jobsite is excluded from warranty, but may be repaired by qualied tech-
nician at the owner’s expense. Do not stand in the tub or store materials in the tub during construction.
Do not store tub in temperatures below 32 degrees Fahrenheit. Proper waste and overow installation is the re-
sponsibility of the installer. MTI does not warrant leaks associated with improper waste and overow installation.