Installation Sheet

AIR BATH INSTALLATION INSTRUCTIONS

1. Select the location for the air blower within 8' of the tub. MTI does not recommend that the the

blower be mounted more than 8' from the tub. The blower must be in a climate-controlled environment.

2. The air hose, keypad cable and drain sensor wires exit the bottom of the bath near the drain, and

must be connected to the blower. See photo "A" below.

3. If your tub includes LED lights, the control box (8) will be placed next to the blower and plugs into

the side of the blower. The wire for the lights will also run between the tub and the blower location.

See photo "B" below.

4. Use care not to crush or kink any of the connections.

5. The blower hose may be extended under the floor using rigid 1" PVC pipe, or an extension

kit may be requested from our service department by calling 800-783-8827 or emailing

customerservice@mtibaths.com. The keypad cable is 12' long. If a longer length is needed,

you can purchase a standard Ethernet cable from most home electronics or home improvement

stores. If the drain sensor wire needs to be lengthened, splice in 18 gauge, low voltage wire.

Save the two pin connector to allow reconnection to the blower! Do not attempt to remove the

drain sensors from the bottom of the tub. The blower and air hose must be in a climate-controlled

environment.

1 - Air blower (remote mounted)

2 - Blower hose

3 - Keypad (installed on tub)

4 - Ethernet (keypad) cable

5 - Drain sensor wire

6 - Drain sensors - installed on tub

7 - LED lights - installed on tub

8 - Control box (remote mounted)