Installation Sheet

12
#2 STANDARD WHIRLPOOL
FUNCTIONS
PUMP ON
1st Press: The pump starts. Use the air volume control to adjust.
PUMP OFF
1st Press: The pump stops.
# 3 STANDARD WHIRLPOOL /
AIR BATH COMBINATION
FUNCTIONS
ON/OFF PUMP
1st Press: The pump starts. Light on.
2nd Press: The pump stops. Light off.
ON/OFF BLOWER
1st Press: The blower starts. Light on.
2nd Press: The blower stops. Light off.
BLOWER SPEED INCREASE
Press & hold to increase the blower speed. Release pressure at the desired speed.
Note: The blower initially starts at half speed.
BLOWER SPEED DECREASE
Press & hold to decrease the blower speed. Release pressure at the desired speed.
PULSATION MODES - AIR SYSTEM
1st Press: Wave - Speed will vary gradually from maximum to minimum. LED light on.
2nd Press: Pulse - Speed will go directly to minimum and then straight back to maximum. LED light
will flash.
3rd Press: Returns to maximum speed. LED light off. Press button #4 to decrease blower speed.
AUTOMATICALLY STOPS AFTER 20 MINUTES
NOTE: The air blower will turn on by itself approximately 7 minutes after tub is completely drained.
See p. 19 for more information.
OR STREAM BATH WITH AIR SYSTEM