Specifications

UNPACKING YOUR ENGINE
Removing and Unwrapping Your Engine
Carefully remove and unwrap the model on a soft surface. By nature, models with
high levels of detail have some small fragile parts.
Carefully remove any foam packing pieces that may be surrounding the model.
What Else is in the Box?
The following items are packed with your engine.
Engineer's Guide (1)
You probably know that since you're reading it.
Couplers (2) - already attached
Mechanical NEM 362 Couplers and mounting assemblies
M.T.H. HO GG-1 Electric Engine
4
Unpacking and Unlatching
Your MTH HO Engine is equipped with Remotely Controlled, Directionally
Activated Operating Pantographs. When unpacking the engine the Remotely
Controlled, Directionally Activated Operating Pantographs are latched in the
down position. To unlatch the pantographs hold the pantograph at the sides of
the base and pull up on the slider.
Removing and Re-Installing Pantographs
When re-installing the pantographs, make sure that the sliding actuator blocks in
the slots of the roof are pushed to the outer ends of travel. You may have power up
the engine and make direction change for one of the pantographs.
Collapse the pantograph and align the 4 insulator details with the 4 holes in the roof.
Also align the actuator tang with the slot in roof, while making sure that the actuator
tang is situated between the two sliding actuator block in each slot in the roof.
Apply slight pressures so that the insulator details are inserted in the roof holes and
the holes in the pantograph frames.