Specifications

M.T.H. HO GG-1 Electric Engine
3
QUICK START GUIDE
Of course, you should read your manual over before running your
engine. But if you just can’t wait, choose how you want to run below and
enjoy!! Now, after a few minutes, shut the engine down and read through
your engineer’s guide.
CAUTION: M.T.H. P.S. 3E+ HO engines OPERATE ON AC
VOLTAGE and are designed to operate on HO 3-Rail Stud-rail track.
I USE AN AC SUPPLY…
Step 1: Unpack your Engine. (refer to unpacking instruction on pg 4)…
Step 2: Set the engine on the track …
Step 3: Apply AC voltage to the track and increase the voltage until the engine
moves out and reaches your desired speed...
Note: AC Power only works for the 3 rail HO Model. Running a 2
rail HO Engine on AC power will permanently damage the engine.
I USE A REGULAR DC SUPPLY…
Step 1: Unpack your Engine. (refer to unpacking instruction on pg 4)…
Step 2: Set the engine on the track …
Step 3: Apply DC voltage to the track and increase the voltage until the engine
moves out and reaches your desired speed...
I'M A DCC/MOTOROLA OPERATOR….
Step 1: Unpack your (refer to unpacking instructions on pg 4)…
Step 2: Set the engine on the track …
Step 3: Power up your DCC system…
Step 4: Select engine address 3 and press “F3” to start the engine sounds
and lights...
Step 5: Turn the throttle and head on down the pike…
I RUN DCS….
Step 1: Unpack your Engine. (refer to unpacking instructions on pg 4)…
Step 2: Set the engine on the track …
Step 3: Power up your DCS system…
Step 4: Add the engine to your DCS remote then press the “START UP”
button...
Step 5: Turn the throttle and move out….
*Please note, when making setting changes in DCS or DCC, such as address, please
wait a minimum of 5 seconds after removing power to insure the settings are stored in
the engines memory. Reapplying power in less than 5 seconds may result in losing
the setting changes.
Engine.