Specifications

2. Slowly reduce the throttle until the train stops at the desired location and

speed reaches zero. Press the F4 button twice (toggle F4 on then off) again and

the bell will stop ringing. You will hear the engine sounds switch from the cab

to the station or yard with all the ambient sounds you'd hear in the real thing.

3. Press the F4 button twice (toggle F4 on then off) again to advance the sequence.

You'll hear “Now boarding…” for passenger sound sets and freight yard sounds

for freight sound sets.

4. Press the F4 button twice (toggle F4 on then off) again to advance the sequence.

You'll hear “Now departing…” for passenger sound sets and more freight yard

sounds for freight sound sets.

5. Press the F4 button twice (toggle F4 on then off) the last time to advance the

sequence. You'll hear “All aboard…” for passenger sound sets and more freight

yard sounds for freight sound sets. The engine sounds will switch over to the

cab again. When the bell begins to ring, advance the throttle to move the

engine out of the station or yard. The bell will shut off automatically.

Lights

F5 – Lights

This toggles all your lights (except the headlight) on and off

Master Volume

F6 – Master Volume

There are 10 volume levels. Pressing F6 twice (toggling on then off) raises the

Master Volume one level. The Master Volume loops. That is, if you go past the

th st

10 level it will loop back around to the 1 or lowest volume level.

Forward/Reverse Signal

Just like a real engine, you can announce the direction of travel using your DCC

handheld and F9 and F10.

F9 – Forward Signal

Pressing F9 twice (toggling on then off) will sound the Forward Signal. This is

two whistle/horn blasts

F10 – Reverse Signal

Pressing F10 twice (toggling on then off) will sound the Reverse Signal. This is

three whistle/horn blasts

M.T.H. HO GG-1 Electric Engine