Operator`s manual

Problem Cause Remedy
Engine Fails to start
1. Spark plug wire disconnected
2. Fuel tank empty or stale fuel
3. Throttle control lever (if equipped) not in
correct starting position
4. Choke not in ON position
5. Blocked fuel line
6. Faulty spark plug
7. Engine flooding
1. Connect wire to spark plug
2. Fill tank with clean, fresh gasoline
3. Move throttle lever to start position
4. Move lever to ON position
5. Clean fuel line
6. Clean, adjust gap, or replace
7. Wait a few minutes to restart, but do not prime
(if equipped)
Engine runs erratic Spark plug wire loose1.
Unit running on CHOKE2.
Blocked fuel line or stale fuel 3.
Vent plugged4.
Water or dirt in fuel system5.
Dirty air cleaner6.
Carburetor out of adjustment7.
Connect and tighten spark plug wire1.
Move choke lever to OFF2.
Clean fuel line; fill tank with clean, fresh 3.
gasoline
Clear vent4.
Drain fuel tank. Refill with fresh fuel5.
Clean following engine manual6.
Refer to engine manual7.
Engine overheats Engine oil level low1.
Dirty air filter2.
Air flow restricted3.
Carburetor not adjusted properly4.
Fill crankcase with proper oil1.
Clean air cleaner2.
Remove blower housing and clean3.
Refer to engine manual4.
Tines do not engage Foreign object lodged in tines 1.
Tine clevis pin(s) missing2.
Belt worn and/or stretched3.
Pulley and idler not in correct adjustment4.
Stop tiller completely, check and discard 1.
foreign object
Replace tine clevis pin(s)2.
Replace belt3.
Take unit to authorized service4.
Troubleshooting
8
14