Specifications

TM5-6115-585-34
NAVFAC P-8-262-12
TO-35C2-3-455-2
TM-05684C-34
WARNING
All specific cautions
adhered to. Otherwise,
result.
and warnings contained in this manual shall be strictly
severe injury, death and/or damage to the equipment may
HIGH VOLTAGE
is produced when this Generator Set is in operation.
DEATH
or severe burns may result if personnel fail to observe safety precautions. Do not
operate this Generator Set until the ground terminal stud has been connected to a
suitable ground. Disconnect the battery ground cable before removing and installing
components on the engine or in the electrical control panel system. Remove all
rings, watches, and other jewelry when performing maintenance on this equipment.
Loose fitting clothing should be secured to prevent it catching in moving parts. D
O
not attempt to service or otherwise make any adjustments, connections or recon-
nection of wires or cables until Generator Set is shut-down and completely de-
energized.
DANGEROUS GASES
Batteries generate explosive gas during charging: therefore, utilize extreme
caution, do not smoke, or use open flame in the vicinity of the Generator Set when
servicing batteries.
Exhaust discharge contains noxious and deadly fumes. Do not operate Generator
Sets in enclosed areas unless exhaust discharge is properly vented to the outside.
To avoid sparking between filler nozzle and fuel tank, always maintain metal to
metal contact between filler nozzle and fuel tank when filling fuel tank.
Do not smoke or use open flame in the vicinity of the Generator Set while fueling.
LIQUIDS UNDER HIGH PRESSURE
are generated as a result of operation of the Generator Set. Do not expose any
part of the body to a high pressure leak in the fuel injection system.
WARNING
Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and pro-
longed exposure of skin to cleaning solvent. Wash exposed skin thoroughly. Dry
cleaning solvent (Fed. Spec. P-D-680) used to clean parts is potentially dangerous
to personnel and property. Do not use near open flame or excessive heat. Flash
point of solvent is 100° F. to 138° F. (38° C. to 59° C.).
WARNING
If conditions require fuel tank repairs by welding or other methods involving heat
or flame, take care to assure that all fumes are purged from the tank or fill tank
with water before commencing the repair. If possible, tank should be filled with
water prior to welding after being thoroughly purged of fumes. Applying heat or
flame to a fuel tank containing residue, may result in a violent explosion, causing
death or injury to maintenance personnel.
NOISE
Operating level of this generator can cause hearing damage.
recommended by the medical or safety officer, must be worn
this set.
Ear protectors, as
when working near