Specifications
Table Of Contents
- INTRODUCTION
- OVERVIEW
- SPECIFICATIONS
- ARCHITECTURE OVERVIEW
- MASTER CLOCK
- PLD1
- PLD2
- CCD CLOCK DRIVERS
- CCD BIAS VOLTAGES
- CCD IMAGE SENSOR
- A/D CONVERTER: ANALOG DEVICES AD9816
- EMITTER FOLLOWER
- AC COUPLING CAPACITOR
- POWER ON CLEAR / RESET
- JTAG HEADER
- UNIT INTEGRATION TIME
- J6 INPUT CONNECTOR
- J4 OUTPUT CONNECTOR
- J7 INTEGRATION SYNC
- J1, J2 IMAGER BOARD CONNECTORS
- POWER SUPPLIES
- J5 POWER CONNECTOR
- BOARD REQUIREMENTS:
- CONFIGURATION MODES
- CCD IMAGER BOARDS
- TIMING
- OTHER PARAMETERS
- FIGURES, TABLES, TIMING DIAGRAMS, AND PERFORMANCE DATA
- REFERENCES
- ORDERING INFORMATION
- WARNING: LIFE SUPPORT APPLICATIONS POLICY
- REVISION CHANGES
- APPENDIX
SPECIFICATIONS
Maximum Data Rate 6MHz
Resolution 12 Bits
Frame Rate Depends on Data Rate, CCD Array size, and Integration time.
OUTPUTS:
D[11..0] Differential TTL
Frame Grabber Syncs Differential TTL
Integration Sync TTL
INPUTS: TTL
Serial Clock 10 MHz Maximum
PGA Gain Range 1X to 6X
PGA Gain Resolution 256 steps
Offset Range -100mV to +100mV
Offset Resolution 256 steps
Temperature Range Board 0 - 70°C
Temperature Range CCD -50 to +70°C typical
Power Supplies Typical Current
Switching Power Supply
Supply Minimum Nominal Maximum Disabled Enabled
+5V +4.9V +5V +5.1V 1000mA 1500mA
+18V +17V +18V +20V 120mA -
-18V -20V -18V -13V 100mA -
Electrons per A/D count 29.2 @ 5MHz, 2.5X Gain setting (Assuming on-chip CCD amplifier gain CCD of
10µV/electron)
RMS Dark Noise 1.9 LSB typical @ 5MHz, 2.5X Gain setting
System Noise Floor 56 electrons @ 5MHz, 2.5X Gain setting (Assuming on-chip CCD amplifier gain of
10µV/electron)
©Eastman Kodak Company, 2008 www.kodak.com/go/imagers Revision 8.0 MTD/PS-0215 p6