Instructions / Assembly

ManualsBrandsMTD ManualsOutdoorsDeluxe Sunshade for Tractors

FORM ORI30134 112000 1

MTD SUNSHADE

#30134

MTD PART # 190-607-000

OPERATION – PARTS LIST - ASSEMBLY

IMPORTANT

PLEASE READ THIS OPERATION MANUAL CAREFULLY AND COMPLETELY

BEFORE BEGINNING INSTALLATION AND KEEP FOR FUTURE REFERENCE

CAUTION

ALWAYS REMOVE SUNSHADE FROM MACHINE BEFORE TRANSPORTING

MACHINE ON AN OPEN TRAILER OR IN AN OPEN TRUCK WHOSE SPEED WILL

EXCEED 25 M.P.H.

! ! WARNING ! !

THIS SUNSHADE WILL NOT PROTECT THE OPERATOR FROM INJURIES

CAUSED BY ROLL-OVER, COLLISION OR OTHER ACCIDENTS

Summary of content (4 pages)

PAGE 1
MTD SUNSHADE #30134 MTD PART # 190-607-000 OPERATION – PARTS LIST - ASSEMBLY IMPORTANT PLEASE READ THIS OPERATION MANUAL CAREFULLY AND COMPLETELY BEFORE BEGINNING INSTALLATION AND KEEP FOR FUTURE REFERENCE CAUTION ALWAYS REMOVE SUNSHADE FROM MACHINE BEFORE TRANSPORTING MACHINE ON AN OPEN TRAILER OR IN AN OPEN TRUCK WHOSE SPEED WILL EXCEED 25 M.P.H.
PAGE 2
MTD Fast-Attach Sunshade Model #30134 PART # 30146 30147 30148 30149 30150 9347 9348 30070 30071 9290 9291 9349 9351 30081-W 30151 786 730 784 729 9904 6835 KEY # A B C D E 3 4 5 6 7 8 9 10 HWP HWP HWP HWP HWP HWP QTY 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 10 10 6 6 1 1 FORM ORI30134 112000 DESCRIPTION RECEIVER, RH RECEIVER, LH BRACKET, RECEIVER BRACKET, LOWER “L” CROSSBAR POST, RH POST, LH FRONT BOW (Tapered End) FRONT BOW TOP BOW REAR BOW BRACE, RH BRACE, LT COVER, VINYL HARDWARE PACKAGE (Contents listed below
PAGE 3
INSTALLATION INSTRUCTIONS SUNSHADE MODEL #30134 The right side of the machine is determined from the operator’s seated position. The word “bolt” will refer to a 1/4” x 5/8” capscrew and the word “nut” will refer to a 1/4” locknut unless otherwise specified. The number in brackets [#] after a part description in the text refers to the key number for the part on the parts list and in figures 1 and 2.
PAGE 4
STEP 3; SEE FIGURE 2: STEP 4: Attach posts & braces to shade frame: RH & LH POSTS [3 & 4] RH & LH BRACES [9 & 10] Install: SUNSHADE ASSEMBLY A. Lightly lubricate square ends of posts with wax or bar soap. A. Fold top bow down onto front bow and turn assembly completely over. B. Holding assembly by round part of post. Slide square ends of post into square ends of RECEIVERS [A & B]. Allow posts to go as far into receivers as possible. DO NOT FORCE. B.