Front Sweeper FK 105 A08 FORM NO.
Operating Manual FK 105 Table of Contents Contents: ...................................................................................... Page Unpacking / Mounting ...................................................................................... 3 For your safety .................................................................................................. 3 Use the machine properly.................................................................................. 4 Signs on the machine...........
Operating Manual FK 105 The Front Sweeper Type FS 102/33 described below is only suitable for attachment to lawn tractors in the series 48../49../50.. and 51... Identification of the model number: The type plate is located under the driver's seat. The fifth and sixth positions of the model number are the series. Example: Model number l3BW506N690 = 50.. Series Model number 13AT491N684 = 49..
Operating Manual FK 105 Use the machine properly This machine is intended for use − as a front sweeper for lawn tractors for sweeping domestic and leisure property − according to the specifications and safety instructions contained in this operating manual. Any other use shall be deemed to be improper use. The user is liable for all damage to third parties and their property. Unauthorised modifications to the machine shall exclude any liability of the manufacturer from any damage which may result.
Operating Manual FK 105 Signs on the machine Important: Read the operating instructions before starting up. Important: Danger of injury / damage to the machine. The maximum speed of 6 km/h must not be exceeded. Keep third parties out of the danger zone. Always keep these signs on the machine in a legible condition. Maintenance Only allow maintenance work / repairs to be carried out by a specialist workshop. Only use original spare parts or spare parts which have been approved by the manufacturer.
Operating Manual FK 105 Mounting Preparing the lawn tractor for mounting the front sweeper 1. 2. For technical safety reasons, a cable bridge according to the instructions below must be installed for the attachment of the sweeper. The installed cable bridge between brake switch and seat safety switch ensures that the engine always automatically switches off as soon as the operator leaves the driver's seat.
Operating Manual FK 105 4. Open the black cable harness sheath from the wiring harness to the brake switch (between step and frame) and expose the yellow/white cable. right footboard 5. Connect the free end of cable "A" to the yellow/white cable with a branch connector "B". A B 6. Press all the cables back into the cable harness sheath and fasten the cable "A" in parallel with the cable harness using 3 cable ties. 7. Replace right-hand side panel and/or fuel tank (depending on design). 8.
Operating Manual FK 105 9. Lower the mower on to e.g. squared timber so that the strain relief clamp on the front side of the deck is not stressed. 10. Unbolt the strain relief clamp from the cross member "D" on the front of the machine and replace it with the supplied deck suspension "E". Re-adjust the tension distance according to the original strain relief clamp. D View from front right E 11. Undo the fixing bolt of the engine V-belt pulley.
Operating Manual FK 105 ___________________________________________________________________________ 13. Before the sweeper can be coupled, the connection pieces for the MTD "Fast Attach System" must be bolted on. Match the parts to the correct side according to the illustration and attach each part using 2 bolts, 2 washers and 2 nuts. Sweeping machine Thin washer Hex. Bolt M8x25 Connection piece left Thick washer Lock nut M8 14.
Operating Manual FK 105 Attachment of the front sweeper 1. Place the sweeper in position in front of the lawn tractor. Turn the locking element "G" flat as shown in the picture. Hold the knob "H" with your left hand and the bracket "J" with your right hand and lift the hook ends of the connecting plates onto the bolts of the Fast-Attach-System "K". H J G K 2. In the next step, you place the V-belt on the extra pulley as shown in the picture.
Operating Manual FK 105 3. Now swivel the locking elements "G" so that they engage in the holes of the side plates. Go in front of the sweeper, hold the front edge of the brush deck and lift this until the locking elements audibly engage in the tractor bore holes of the Fast-Attach-System. The sweeper is coupled and the V-belt to the tractor has been correctly tensioned by the spring-mounted tensioner. G V-belt 4. Push the lifting tube "M" onto the lever of the sweeper on the right-hand side.
Operating Manual FK 105 Removal of the front sweeper 1. Switch off the engine of the tractor. The sweeper is raised. Wait until all parts are at a standstill. Let the exhaust area cool down or use suitable work gloves. Remove the lifting tube and the extension tube of the swivel rod from the sweeper. In order to pull out the locking elements "G" of the Fast-Attach-System and to fold on to the sides, hold the front edge of the brush deck and lift this at the same time. Lower the sweeper on to the ground.
Operating Manual FK 105 Operation of the front sweeper 1. The sweeper is raised or lowered with the lifting tube "M". For raising, the bar is simply moved up and down in relation to the step using the handle until the sweeper completely engages in the "top position". For lowering, the bar is lifted at the handle. After a slight resistance, the lowering occurs slowly. M 2.
Operating Manual FK 105 Tafel 1 Spare Parts List MTD FK 105 16 1 25 27 24 23 22 13 21 26 2 15 16 20 19 29 8 14 7 8 9 5 6 28 18 17 30 16 22 10 12 33 31 39 49 4 3 30 11 32 54 55 38 41 40 34 29 37 35 35 47 56 36 42 44 45 44 43 52 48 46 14 51 50 52 53
Operating Manual FK 105 Spare Parts List MTD FK 105 Pos. Artikel-Nr. ohne Abb. Bezeichnung 4HM-Q06 Kehrbürstenwalze 33-10P 1 FKT-167 2 Tafel 1 Pos. Artikel-Nr. (2x =1m) Bezeichnung 36 4HO-A08 Z1 6kt-Schraube M6x16 Bürstendeck MTD 100 37 4HW-B06 Z1 Scheibe, groß Ø 6 FKT-261 Bürstengetriebe MTD 38 4KC-B56 Führungsstift 3 4KB-S05 Schneckengetr.
Operating Manual FK 105 Spare Parts List MTD FK 105 64 63 66 Tafel 2 66 67 64 63 65 65 62 61 69 68 70 72 92 74 70 71 71 81 79 80 76 67 73 84 71 70 91 78 75 83 72 85 86 88 90 77 82 87 79 88 89 67 79 101 102 103 105 108 84 85 93 94 104 97 99 109 98 84 106 111 110 107 100 16 96 95
Operating Manual FK 105 Spare Parts List MTD FK 105 Pos. Artikel-Nr. Bezeichnung Pos. Artikel-Nr. Tafel 2 Bezeichnung 61 4DA-G27 Z Kupplungsblech MTD li. 97 FTS-179 Z Zugbügel M500 62 4DA-G26 Z Kupplungsblech MTD re.
