Manual

SECTION 5: ASSEMBLY INSTRUCTIONS

IMPORTANT: After assembly, service engine with

gasoline, and check oil level as instructed in the

separate engine manual packed with your unit.

NOTE: All references to right or left side of the

snow thrower are determined from behind the unit in

the operating position.

UNPACKING

TOOLS REQUIRED FOR ASSEMBLY

• (1) 3/8" Wrench

• (2) 7/16" Wrench*

• (2) 1/2"Wrench*

• 9/16" Wrench

• Pair of pliers

*or adjustable wrench

• Remove staples or break glue on the top flaps

of the carton. Remove any loose parts

included with unit (i.e., Operator's Manual, etc). A (2) Handles (Right and Left)

B (1) Handle PanelAssembly

• Cut along dotted lines and lay end of carton C (1) Chute Assembly

down flat. Remove packing material. D (1) Chute Crank Assembly w/Upper

• Roll unit out of carton. Check carton Mounting Bracket

thoroughly for loose parts before discarding. E (1) Shift Rod

(1) Hardware Pack (not illustrated)

LOOSE PARTS IN CARTON See Figure 3

Figure 3