Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting 's • Warranty L Self Propelled Mower m Model E46J MTD LLC, P.O. BOX 361131 CLEVELAND, OHiO 44136-0019 PrintedIn USA FormNo.
1 ToTheOwner ThankYou Thank you for purchasing It was carefully when properly a Lawn Mower Please read this entire manual It instructs manufactured engineered to provide excellent operated and maintained. by MTD. in this manual prior to operating the equipment. you how to safely and easily set up, operate maintain your machine. persons who will operate Manual may cover a range of product specifications for various models.
2 importantSafeOperationPractices WARNING: This symbol could endanger points out important the personal all instructions safety and/or in this manual with these instructions before property attempting may result in personal When you see this symbol. safety instructions of yourself to operate which, if not followed, and others. this machine. Read and follow Failure to comply injury.
12. Amissing ordamaged discharge cover cancause blade contact orthrown object injuries. 13. Many injuries occur asaresult ofthemower beingpulled overthefootduring afallcaused byslipping ortripping. Donotholdontothemower ifyouarefalling; release the handle immediately. 14. Never pullthemower back toward youwhileyouare walking. Ifyoumustback themower away fromawallor obstruction firstlookdownandbehind toavoid tripping andthenfollowthese steps: a. Stepback frommower tofullyextend yourarms. b.
Service 3. Check the blade and engine intervals To avoid personal care in handling injury or property damage gasoline. Gasoline is extremely can ignite. Wash your skin and change flammable clothes original 3. Use only an approved Never fill containers gasoline container. inside a vehicle 4. Remove gas-powered equipment Keep all nuts, bolts, and screws tight equipment 7. trailer and refuel it on the ground.
SparkArrestor Notice Regarding Emissions Engines which are certified to comply with California and federal EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate may include the following Modification (EM), Oxidizing Injection on regular emission unleaded control gasoline, and internal combustion engine and should not be used WARNING: This machine is equipped with an on or near any unimproved forest-covered, brush i_ll systems: Engine Catalyst (OC), Secondary A
Safety Symbols This page depicts and describes safety symbols that may appear machine before attempting to assemble and operate. on this product. Read, understand, and follow all instructions on the READ THE OPERATOR'S MANUAL(S) Read, understand, assemble and follow all instructions in the manual(s) before attempting to and operate DANGER -- ROTATING BLADES To reduce the risk of injury, keep hands and feet away. Do not operate or grass catcher is in its proper place.
co Sight and hold this level with a vertical tree... -4 5 Z I ,_ or a corner of a building... i i Z __ I i I I O ' FOldo, 5 ' Z "o or a fencepost ', diine , --Lepre_n tsa15 o -4 I I 15 ° Usethis page as a guide to determine slopes where you may not operate safely. WARNING: Do not operate (a rise of approximately mowers up and down up and down slopes. your lawn mower on such slopes. Do not mow on inclines with a slope in excess of 15 degrees 2-1/2 feet every 10 feet).
3 Assembly& Set-Up Contents of Carton One Lawn Mower One Lawn Mower One Grass Catcher One Side Discharge Assembly Operator's 2. without Fill up gasoline and oil as instructed section BEFORE operating gasoline or oil in the engine. in the Engine Operation One Bottle Insert a carriage bolt found in the manual hole on the handle mounting Remove any packing material upper and lower handles. which Pull up and back on upper lifting Carria_olts handle as shown in Fig.
3. The rope guide is attached handle. to the right side of the upper See Fig. 3-3. Loosen the wing nut which b. secures the Slip plastic channel of grass bag over hooks on the frame. See Fig. 3-4. All the plastic rope guide. channels except center top of bag attach from outside of frame. F Figure 4. Figure 3-4 3-3 a. Hold blade control against upper b. Pull starter control. rope out of the engine. c. Slip starter rope into rope guide. d. Tighten handle. Release blade c. 2.
Side DischargeChute Your mower is shipped make sure grass catcher is closed. 1. Adjustments as a mulcher. To convert to side discharge, is off of the unit and rear discharge door CuttingHeight Each wheel has a height adjustment On the side of the mower, 3-6. lift the mulching plug. See Figure height lever to change the cutting of the mower. 1. Depress height adjustment 2. Slide lever to desired height. lever towards position wheel. for a change in cutting See Fig. 3-7.
4 Controls and Features Drive Controk Electric Start ignition Switch Recoil Starter Primer Side Discharge Chute Cutting Height Adjustment . Levers / Figure 4=1 BladeControl MulchPlug The blade control is attached to the upper handle of the mower. Depress and squeeze it against the upper handle to operate the The mulch plug is used for mulching purposes. collecting the grass clippings in a grass catcher unit. Release it to stop engine and blade.
Operation F Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower. 1. Push primer 3 times. Wait about two seconds between each push. SeeFig. 5-1. In temperature below 50°F, prime 5 times.
Maintenance & Adjustments Maintenance 2. Lubricate motor General Recommendations Always observe maintenance. The warranty at least once a season with light oil (or are removed safety rules when performing does not cover items that Lubricate the torsion discharge door and side mulch plug periodically oil to prevent spring and pivot points 4. The transmission is pre-lubricated and does not require lubrication. Changing 5.
Engine Care ReplacingRearFlap NOTE: Refer to the Engine Operation and Maintenance in this manual for detailed instructions. Maintain sections oil level. 1. To remove rear flap, lift rear door, and press flap in on either side to remove from hole. See Fig. 6-2. r Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty conditions. Clean spark plug and reset the gap once a season. Clean engine regularly with a cloth or brush.
7 Service Blade Care 5. Lubricate the engine the blade adapter WARNING: sharpening When removing or replacement, the cutting protect blade for inspect the blade adapter strike a foreign object. Replace when below for blade service. 1. for cracks, especially necessary. part number) Disconnect spark plug boot from spark plug. Turn mower on its side making sure that the air filter and the carburetor are facing up. 2. operating faces the ground position.
4. Press inward ontabontheengine baffle torelease itfrom thebafflebracket. See Fig.7-3. 6. Replace with new belt, making engine pulley while it around 7. the transmission Reattach engine in the previous 8. pulling Turn mower sure belt is firmly pulley. baffle and reassemble blade as described section. back over and make sure belt is seated on the transmission pulley. Tighten screw loosened secure belt tension spring to the transmission. 9.
NOTE: The battery you have may differ slightly one shown in Fig. 7-6. Refer to the Parts List. from the Charaina Battery and toxic material; handle with care and keep away WARNING: containsdisassemble, corrosive fluid from children. The Do battery not puncture, ÷ mutilate or incinerate Positive could be vented Terminal in a well ventilated Negative Terminal the battery. during charging Explosive gases or discharging. Use area, away from sources of ignition.
ReplacingFuse Off-SeasonStorage The electric starter circuit and battery are protected by a 40 ampere fuse. If the fuse burns out, the electric starter will not The following for storage. operate. If the unit fails to start with the electric the following 1. Open the battery See Fig. 7-5. 2. Remove fuse from socket and inspect If it is burned ampere starter, steps to check the fuse inside the battery cover as described out, replace in Replacing perform housing: Battery. as shown in Fig. 7-8.
Troubleshooting Problem Engine Fails to start Cause 1. Remedy Blade control disengaged. 2. Spark plug boot disconnected. 2. Connect wire to spark boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Engine not primed (if equipped with primer). 4. Prime engine as instructed section. in the Operation 5. Faulty spark plug. 5. Clean, adjust gap, or replace. 6. Blocked fuel line. 6. Clean fuel line. Z Engine flooded. Z Waita few mmutes to restart, butdo not prime.
Problem Cause Uneven cut 1. Wheels not positioned Remedy correctly. 1. Place all four wheels in same height (if equipped 2. Dull blade. i : with individual position height adjusters). 2. Sharpen or replace blade.
EngineOperation Fuel Cap \ Primer Air Cleaner Grip Cap OU Drain Spark Plug Mumer Figure 9=1 Pre-0peration Check Oil Recommendations NOTE:This engine is shipped engine. Running the engine serious engine damage Before starting without with insufficient engine, is about 20 oz. Use a 4-stroke, or an equivalent motor oil certified 20 Oil mlmlllm Iilmllm high detergent, SG/SF. on the for general, all temperature in your area from m,3o premium U.S.
Check0il Level CheckFuel Level NOTE: Be sure to check the engine on a level surface with the 1. Clean around 2. Fill tank to approximately engine stopped. 1. Remove the oil filler cap and wipe the dipstick Fig. 9-2. clean. See fuel fill before neck to allow removing 1-inch below for fuel expansion. NOTE: Before refueling, cap to fuel. lowest portion of Be careful not to overfill. allow engine to cool 2 minutes.
1 EngineMaintenance Periodic any maintenance. To prevent accidental ARNING: the Shut offthe disconnect spark plug engine boot. before _ inspection If engine must be tipped to transport of the engine is essential is to be maintained. Regular maintenance will also ensure a long service life.
AirCleanerService Oil Service Check oil level regularly. Paper filters cannot Be sure correct or every 100 operating dusty conditions. oil level is maintained. hours or daily before starting procedure in the Operation engine. Check every five See oil checking be cleaned and must be replaced section. solvents for cleaning thegasoline air cleaner element. A fire WARNING: Never use or low flash point or explosion could result.
SparkPlugService 3_ necessary by bending side electrode. should be set to 0.030 in. plug removed. DODONOT NOT crankforengine WARNING: check spark _ Measure the plug gap with a feeler gauge. Correct as See Fig. 10-4. The gap with with spark spark plug removed. To ensure proper engine operation, properly and free of deposits. 1. gapped the spark plug must be Remove the spark plug boot and use a spark plug wrench Electrode to remove the plug. See Fig. 10-3.
Fuel Filter Service The fuel filter cannot Storage be cleaned year or every 100 operating gasoline. 1. 2. and must be replaced once a hours; more often if run with old Remove all fuel from tank by running from lack of fuel. engine Engines stored between until it stops in fuel system or on essential your engine deteriorates Remove c-clamp from fuel line and remove tank outlet. See Fig. 10-5.
TheEZStartPromise ProvisionsofYourLimitedWarranty In addition to the other terms and conditions of the Limited Warranty applicable to your new mower, MTD LLC ("MTD") hereby warrants that your mower's engine will start on the first or second attempt by an able-bodied adult (subject to the limitations described below) for the duration of the manufacturer's limited warranty applicable to your product.
12 ReplacementParts 1- _ Component ® 0 Phone (800) 800-7310 serial number or (330) 220-4683 ready). Parts Manual to order replacement downloads are also available Part Number and Description 951-10292 Spark Plug 951-10298 Air Cleaner Kit 951-10300 Fuel Cap Assembly 951-10358 Fuel Filter 634-0190 734-1987 Wheel (Front) Wheel (Rear) 731-04177 Discharge Chute 942-0741A Mulching parts or a complete Parts Manual Blade (have your full model number free of charge at www.mtdproducts.
Component [ Part Number 964-04007A Phone (800) 800-7310 serial number or (330) 220-4683 ready). Parts Manual to order replacement downloads are also available and Description Grass Bag 954-0637A Belt 725-04329 Battery Charger 925-04323 Battery 925-0201 Key parts or a complete Parts Manual (have your full model number and free of charge at www.mtdproducts.
FEDERAL and/or CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS MTDConsumerGroupInc,the United StatesEnvironmentalProtectionAgency (EPA),and, forthose productscertifiedfor sale in the stateof California,the CaliforniaAir ResourcesBoard(CARB)are pleasedto explainthe emission(evaporativeand/or exhaust)controlsystem(ECS) warrantyon youroutdoor 2006 andlater smalloff-roadspark-ignitedengine andequipment(outdoorequipmentengine)In California,new outdoorequipmentengines must
WARRANTED PARTS: The repairor replacementof any warrantedpart otherwiseeligiblefor warrantycoveragemay be excludedfrom such warrantycoverageif MTDConsumerGroup Inc demonstratesthatthe outdoor equipmentengine has beenabused,neglected,or improperlymaintained,and thatsuch abuse, neglect,or impropermaintenancewasthe direct causeof the needfor repairor replacementof the part.
MANUFACTURER'S LiMiTED WARRANTY The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States and/or its territories and possessions, and by MTD Products Limited with respect to new merchandise purchased and used in Canadaand/ or its territories and possessions (either entity respectively, "MTD").
