Technical data

7EN 10/2010 i-KI MTD / i-KIR MTD
Safety valve
Air vent valve
Air vent
valve
Pressure gauge
HEAT PUMP
i-KI / i-KIR 0031m
Terminal block
Board with display
Heat exchanger
Expansion
vessel
Compressor
Water inlet
Water outlet
Water pump
DESCRIPTION OF STANDARD UNIT
I A
These air cooled reverse-cycle chillers with axial-flow fans
operate with R410A refrigerant fluid and are suitable for out-
door installation.
The units are CE marked, as established by the EU direc-
tives, including the latest amendments, and the correspond-
ing approximated national legislation.
They are factory tested and on site installation is limited to
water and electrical connections.
Board
Expansion vessel
Board with display
Safety valve
Air vent valve
Pressure gauge
Terminal block
Water pump
Compressor
HEAT PUMP
i-KI / i-KIR 0011m
INSIDE MODULE
i-EM2 / i-EMR2
VERSIONS AVAILABLE
i-KI MTD air/water heat pump, heating
only, with DC inverter-driven compressors,
domestic hot water production, axial-flow
fans and hydronic unit.
i-KIR MTD reverse-cycle air/water
heat pump with DC inverter-driven
compressors, domestic hot water
production, axial-flow fans and hydronic unit.
The heat pump is supplied complete with an electronic mod-
ule to be installed inside the home’s boiler room. The i-EM2
module, for heating only units, and i-EMR2, for reverse-
cycle units, must be supplied at 230V-50Hz and connected
to the heat pump.
The i-EM2 and i-EMR2 modules come as standard with a
remote display terminal, temperature/humidity probe and
outside air temperature probe for system water outlet tem-
perature set point compensation.
Further information and technical specifications are provided
in the manual supplied with the electronic module.
HEAT PUMP
i-KI / i-KIR 0061m
Main board
Board with display
Terminal block
Pressure gauge
Safety valve
Water pump
Compressor
Air vent valve