Technical data

5EN 10/2010 i-KI MTD / i-KIR MTD

REMOVING THE PACKAGING

The packaging must be removed by the operator using suit-

able protective equipment (gloves, glasses, etc.).

Take special care not to damage the unit. Observe the local

standards in force as regards disposal of the packaging,

using specialist collection or recycling centres.

Do not dispose of packaging materials in the environ-

ment or leave them within reach of children as they may

represent a hazard.

Envelope B located in the inside module contains:

• user manual;

• CE declaration;

• installation - user - maintenance manual

• 2 fittings complete with probe socket;

• remote room control unit A5 (must be installed)

The following probes are already connected to the inside

module and must be positioned in the system:

• DHW storage water temperature probe BT8

• outside air temperature probe BT11 (must be installed)

• probe BT9 only to be installed when supplementary

source is available

•

system return BT1 and outlet BT2 water temperature probes,

to be placed in the probe socket on the fittings supplied

Envelope A located in the outside module contains:

• Condensate drain elbow fitting

• CE declaration

Make sure the components listed above are not lost or mis-

placed.

The installation - user - maintenance manual is an

integral part of the unit and should therefore be read and

kept carefully.

RECEIVING AND HANDLING THE PRODUCT

I A

HANDLING UNPACKAGED UNITS

When the packaging has been removed:

• Remove the base.

• Fit the vibration damping feet (accessories).

• Handle the unit using equipment that is suitable for its

weight (forklift or crane), in compliance with the safety

standards in force (and subsequent amendments).

• Do not drag the unit as the feet may be damaged or break.

Hole Ø22