Technical data

4 i-KI MTD / i-KIR MTD EN 10/2010
H
P
L
Bar code
(compressor side)
B
P
L
H
VISUAL INSPECTION
When the items are consigned by the carrier:
- make sure that the goods delivered correspond to the
description on the delivery note, comparing this against
the data on the packaging label.
- make sure the packaging and the unit are intact.
If damage or missing components are noted, indicate this on
the delivery note. A formal complaint should be sent via fax
or registered post to the After Sales Department within eight
days from the date of receipt of the items.
HANDLING PACKAGED UNITS
The unit should always be handled by qualified personnel
using equipment adequate for the weight of the unit, in com-
pliance with the safety standards in force (and subsequent
amendments).
• Lifting by forklift (1)
Insert the forks under the long side of base, opening the
forks as fare as possible.
• Lifting by crane (2)
Use slings with hooks suitable for the weight being lifted.
Secure the hook to the lifting bracket fixed to the unit, use
always four equal length slings, as shown in the figure, to
ensure the weight is balanced.
The weight of the unit is biased towards the compres-
sor side.
During transport, the unit should be kept in a vertical
position.
STORING THE UNITS
The units must be stored sheltered from direct sunlight, rain,
wind or sand.
Avoid exposing the units to direct sunlight, as the pressure
inside the refrigerant circuit may reach dangerous values
and cause the activation of the safety valves, where fitted.
The units cannot be stacked.
The packaging should not be removed until the unit is
located in the installation site.
RECEIVING AND HANDLING THE PRODUCT
I A
1
HEAT PUMP
2
INSIDE MODULE
i-KI/i-KIR Dimensions 0011m 0031m 0061m
Dimension L mm 985 1040 1120
Dimension P mm 425 550 470
Dimension H mm 865 940 1610
Gross weight Kg 62 91 136
i-EM2/i-EMR2 Dimensions 0011m÷0061m
Dimension L mm 430
Dimension P mm 350
Dimension H mm 180
Gross weight Kg 6,3