Technical data

39EN 10/2010 i-KI MTD / i-KIR MTD
x3 sec.
** The heat pump is not yet operating, the mode has to be selected: heating, cooling, auto or domestic hot water production.
** AUTO automatic mode changeover based on the outside air temperature
ZONE OFF
Press the button for 3 seconds
ZONE ON**
Selecting the operating mode
No operating mode selected.
Heat in OFF.
None Automatic mode changeover Cooling Heating
• Press the mode button
• AUTOMATIC** mode changeover
selected
• Press the mode button
• COOLING mode selected
• Press the mode button
• HEATING mode selected
Selecting the room temperature set point
• Turn the knob
• The room temperature set point
is displayed
• Turn the knob to change the room
temperature set point
• Wait a few seconds for confirmation
• The display shows the room tem-
perature
1 2 3
1 2 3 4
OPERATION AND FUNCTIONS OF THE ROOM CONTROLLER
A
Switching ON
The button enables operation of the pump or the zone valve controlled by the room controller, the heat pump is activated by
selecting the operating mode using the button, as shown below.