Technical data

19EN 10/2010 i-KI MTD / i-KIR MTD
HEAT PUMP AND INSIDE MODULE POWERED SEPARATELY
- If power is supplied to the inside module separately from the heat pump, connect power to the heat pump, the communication
cable from the heat pump to the inside module and power to the inside module, as shown in figure 5.
- Make sure that all the protective devices removed to make the electrical connections have been repositioned before powering
up the unit.
- Reposition the wiring cover on the heat pump and the cover on the inside module and fasten them to the unit
- For all mains power connections, move the main switch QF1 (outside the appliance) to “ON”.
- Make sure that all the protective devices removed to make the electrical connections have been repositioned before powering
up the unit.
- Reposition the wiring cover on the heat pump and the cover on the inside module and fasten them to the unit
- For all mains power connections, move the main switch QF1 (outside the appliance) to “ON”.
- When connecting the circuit breakers and power cables to the inside and outside module make sure phase and neutral are
connected correctly.
3
2
1
L
POWERPOWER
N
PE
C
UN 60
A
B
B
Power cable (B)
Power supply
Power supply
Residual
current
circuit
breaker
QF1
Residual
current
circuit
breaker
QF2
Power cable (A)
Connection cable to inside
electronic module (C)
5
MAINS POWER SUPPLY CONNECTIONS
I A