Operation Manual

30
TROUBLESHOOTING
If you have any further questions, please contact your authorised dealer on site
All information, diagrams and specifications in these operating instructions are based on the latest product information at the
time of going to press. We reserve the right to make changes without prior notice.
ENGINE DOES NOT START
CAUSE REMEDIAL ACTION
Ignition switch set to OFF Set switch to ON
Fuel tank empty Fill fuel tank
Primer not depressed adequately
Slowly and fully depress primer 10 x
Engine flooded Implement the starting process with the choke lever in the
operating position
Waste fuel Fill tank with fresh fuel
Dirty spark plug Replace or clean spark plug
ENGINE DOES NOT RUN CONSTANTLY AT NO LOAD
CAUSE REMEDIAL ACTION
Air filter blocked Clean or replace air filter
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
ENGINE DOES NOT ACCELERATE
CAUSE REMEDIAL ACTION
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
ENGINE HAS NO POWER OR STOPS DURING CUTTING
CAUSE REMEDIAL ACTION
Cutting head entangled with grass Stop the engine and clean the cutting attachment
Dirty air filter Clean or replace air filter
Waste fuel Fill tank with fresh fuel
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel
CUTTING HEAD DOES RELEASE LINE
CAUSE REMEDIAL ACTION
Cutting head entangled with grass Stop the engine and clean the cutting attachment
No line in the cutting head Wind up new line
Coil jammed Replace coil
Cutting head dirty Clean coil and coil housing
Line fused together Pull apart, take out the fused part and wind up the line
again
Line twisted when wound up Pull apart and wind up the line again
Not enough line released Tap the bump head and pull out the line until 10 cm of line
is outside the cutting attachment