User Manual

26 310-2200 EZT
®
ASSEMBLY AFTER A COMPLETE TEARDOWN
If the unit has been torn down completely, the
following summary identifies the assembly
procedures necessary to completely as-
semble the unit. Each assembly procedure is
located by a page reference.
The part reference numbers provided in each
assembly procedure are keyed to the indi-
vidual exploded views, and are also keyed to
the complete unit exploded view on page 26.
1. Install the hydraulic components. See
pages 21-25.
2. Install the input shaft and bypass rod. See
page 20.
3. Install the axle shaft, reduction gears and
expansion plate. See page 18.
4. Install the cog brake and side housing.
See page 17.
5. Fill the transaxle with new oil. See page 9.
6. Install the bypass arm and control arm.
See page 15.
7. Install the transaxle onto the vehicle.
8. Perform the purge procedures listed on
page 10.
www.mymowerparts.com
Hydro Gear Parts or New Units Call 606-678-9623 or 606-561-4983