User Manual

310-2200 EZT
®
23
locate.
(Swashplate/Pump Block)
11. (See Figure 15) Install the pump thrust bear-
ing (35) in the trunnion machined swashplate
(19). NOTE: Place the thin race of the bear-
ing towards the swashplate. The thick race
must face the pistons.
12.(See Figure 13) Place the pump block as-
sembly (4), pistons down, on top of the thrust
bearing in the swashplate (19).
13.Coat the pump running surface with clean
motor oil.
14.Care must be taken to prevent the scaring
or scratching of the center section sealing
face during this step. Insert the shaft of the
swashplate/pump block assembly (Figure
21) into the housing while simultaneously
compressing the pistons in the block. NOTE:
To assist in the installation of these compo-
nents, insert the assembly until 3/4 of the
pump block is covered by the center section.
Then slightly press the shaft end toward the
center section while pushing the shaft into
its bore.
15.Install the input shaft and bypass rod. See
page 20.
16. Install the axle shaft, reduction gears and ex-
pansion plate, if removed. Refer to page 18.
17. Install the side housing and brake. See page
17.
18.Fill the transaxle with new oil. See page 9.
19.Install the bypass arm and control arm. See
page 15.
Figure 12.
Figure 13.
Figure 14.
www.mymowerparts.com
Hydro Gear Parts or New Units Call 606-678-9623 or 606-561-4983